Free Cisco 200-401 Exam Dumps Questions & Answers

What are two benefits of a star network topology? (Choose two.)

• A.  The performance of the entire network is directly dependent on the performance of the hub.
• B.  This network type requires less cable as compared to linear bus topology.
• C.  Any problem which leaves the network inoperable can be traced to the central hub.
• D.  The performance of one of the numerous nodes cannot reflect on the performance of other nodes.
• E.  Disruption of the entire network is not required when adding new machines.

An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?

• A.  Use the no switchport port-security command to allow MAC addresses to be added to the configuration.
• B.  Set the switchport mode to trunk and save the running configuration.
• C.  Use the switchport protected command to have the MAC addresses added to the configuration.
• D.  Enable port security and use the keyword sticky.

Exhibit:

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B.
Which address is the default gateway of Host 3?

• A.  the address of the switch interface that is connected to router interface Fa0/1
• B.  the address of the router interface Fa0/0
• C.  the address of the host that is connected to Network B
• D.  the address of the switch interface that is connected to router interface Fa0/0
• E.  the address of the host that is connected to Network A
• F.  the address of the router interface Fa0/1

How does the optical time domain reflectometer use "backscattered" light to make measurements?

• A.  It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems.
• B.  It correlates the returned light pulses with a location in the fiber.
• C.  It performs wiremapping to measure that all pins are correctly connected.
• D.  It measures light-pulse width to measure that all pins are correctly connected.

Exhibit: Refer to the exhibit. Which port should a PLC with IP address 192.168.3.65 be plugged into in order to communicate to the rest of the network?

• A.  FastEthernet1/4
• B.  FastEthernet1/1
• C.  FastEthernet1/3
• D.  FastEthernet1/5
• E.  FastEthernet1/2