Free Cisco 300-110 Exam Dumps Questions & Answers

A customer has two Cisco Catalyst 9800 Series WLCs named WLC-A and WLC-B in an N+1 configuration with the same WLANs but different Layer 3 interfaces for each WLC, and APs in local mode. WLC-A manages Building A APs and WLC-B manages Building B APs. The customer wants users to remain connected and retain their session state including the IP address when moving between buildings. How must this requirement be incorporated into the design?

• A.  Implement AP groups for each building by using the same name on WLC-A and WLC-B.
• B.  Configure WLC-A and WLC-B in a high-availability cluster and set a mobility MAC address.
• C.  Create a mobility tunnel between WLC-A and WLC-B with the same group name.
• D.  Connect WLC-A and WLC-B by using the redundancy port to sync client sessions.

An engineer is designing a FlexConnect deployment for 40 remote branch offices, each with a 10 Mbps WAN circuit back to a central Catalyst 9800 WLC. Which design consideration must be validated before deployment?

• A.  Each branch must have a local WLC for AP registration.
• B.  The round-trip latency between the AP and the WLC must not exceed 300 ms.
• C.  The round-trip latency between the AP and the WLC must not exceed 20 ms.
• D.  All WLANs must be configured for central switching.

An enterprise is using two wireless controllers to support the wireless network. The data centre is located in the head office. Each controller has a corporate WLAN configured with different SSID names. The APs are installed using a round-robin approach to load balance the traffic. What should be changed in the configuration to optimize roaming?

• A.  Use the same WLAN name for the corporate network on both controllers.
• B.  Place the access points per floor on the same controller.
• C.  Use the same WLAN name for the corporate network on both controllers.
• D.  Move all access points to one controller and use the other as N+1 HA.

An engineer is designing the wired infrastructure to support VoWLAN. Which QoS design should be applied to the switch ports connecting the APs?

• A.  Configure the AP switch port as an untrusted port with a policer at 1 Mbps.
• B.  Apply a default queueing policy without any trust configuration.
• C.  Trust DSCP on the AP switch port so that the CAPWAP outer header marking is preserved.
• D.  Trust CoS on the AP switch port and mark all traffic to DSCP 0.

An engineer must reduce roaming delay for wireless medical carts running a real-time application on an 802.1X-secured WLAN. Which feature should be included in the design to eliminate the full reauthentication on each roam?

• A.  802.11r Fast Transition
• B.  802.11v BSS transition management
• C.  802.11k neighbor lists
• D.  Aironet IE