Free Cisco 300-610 Exam Dumps Questions & Answers

A network engineer is using a Cisco UCS environment connected to a Fibre Channel storage array. The Cisco UCS environment must be connected to an existing SAN network, and several Cisco MDS 9000 Series Switches must be added to increase storage density. The solution must not exhaust the SAN network from the list of available domain IDs after connecting Also, most of the SAN traffic must be mapped from the Cisco UCS blades to a specific group of the fabric interconnect ports.
Which two features must be deployed to meet these requirements? (Choose two.)

• A.  end host mode
• B.  static PIN grouping
• C.  priority flow control
• D.  N-Port lD virtualization
• E.  dynamic port pinning

A network consultant evaluates the Ethernet Adapter Policy configuration to be applied to the Cisco UCS blade servers. The policy must minimize latency and increase throughput for sensitive applications. The solution must increase the CPU data cache hit rate to meet these requirements Which policy is required?

• A.  RDMA
• B.  AIC
• C.  NVM-e
• D.  ARFS

Where does Cisco UCS handle Fibre Channel traffic failover?

• A.  in the hardware on any Cisco UCS VIC adapter
• B.  on a Cisco UCS Fabric Interconnect ASIC in Fibre Channel switching mode
• C.  in the hardware on the Cisco UCS VIC 12xx adapter or later
• D.  on the host, by using multipathing software

A storage administrator experiences a slow file transfer rate when archiving backup files on a tape library drive. The tape drive is connected directly to the Cisco Nexus 7009 switches. The file transfer rate gradually goes down with files that are over 100 GB in size. The requirement is for the file transfer rate to be consistent during the transfer window. Which two solutions meet this requirement? (Choose two.)

• A.  Connect the tape drive with two 10G interfaces in vPC mode.
• B.  Perform a file transfer to the tape drive after business hours.
• C.  Split the files before copying them to the tape drive.
• D.  Compress the files to reduce the data size before copying to the tape drive.
• E.  Increase the tape drive disk size to increase the write speed.

Refer to the exhibit. A Cisco engineer is configuring a data center design scenario with Cisco MDS 9000 Series Switches. The cut-through routing mode is chosen for improved read operation performance. Each iSCSI host requires access to storage through the IPS module. First, the engineer configures the TCP tuning parameters as enabled SACK, the maximum bandwidth of 1 Gbps, buffer size of 4096, keepalive timeout at 1s, and enables Path MTU. Then, the engineer must set the QoS of the ISCSI link. What is the maximum QoS value that must be set for the ISCSI session?

• A.  63
• B.  1
• C.  3
• D.  5