Free Cisco 300-615 Exam Dumps Questions & Answers

Refer to the exhibit.

An engineer is troubleshooting the connectivity between Server-1 and Server-2. Which action resolves the connectivity issue?

• A.  Change all ports on spine switches as port-type fabric
• B.  Configure the same source IP address on NVE and virtual peer link on leaf switches
• C.  Enable BGP advertise pip feature on both leaf switches
• D.  Classify CFS messages for strict priority queue on spine switches

Refer to the exhibit.

An engineer troubleshoots an issue invoking where some Cisco MDS 9000 Series Switches fail to be discovered by other MDS switches in the VSAN. The engineer receives the error message shown Which action resolves the issue?

• A.  Restart the domain manager and reset port 7
• B.  Move port 7 to VSAN 1 to remove the port from isolation
• C.  Assign a new domain ID to the isolated switch
• D.  Assign a new alias to port 7 and reset the port worldwide name.

Refer to the exhibit.

An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?

• A.  Disable the check of the MTU value.
• B.  Adjust the MTU on Router-A to 1600.
• C.  Adjust the MTU on Router-B to 1604.
• D.  Set the OSPF media type to point-to-point.

Refer to the exhibit.

An engineer fails to perform a database merge between two Cisco MDS 9000 Series Switches named switch-1 and switch-2. Which set of commands resolves the issue?

• A.  ( ) On switch-2, run the device-alias rename A1 A2 command.
  On switch-2, run the device-alias database pwwn 21:01:01:01:01:01:01:01 command.
• B.  ( ) On switch-1, run the device-alias database pwwn 21:01:01:01:01:01:01:01 command.
  On switch-2, run the device-alias database pwwn 21:01:01:01:01:01:01:02 command.
• C.  ( ) On switch-1, run the device-alias rename A1 A2 command.
  On switch-2, run the device-alias database pwwn 21:01:01:01:01:01:01:01 command.
• D.  ( ) On switch-1, run the device-alias rename A3 A123 command.
  On switch-2, run the device-alias rename A1 A123 command.

Refer to the exhibit.

An engineer is performing a health check on ACI. Which statement about interface Ethernet 1/11 is true?

• A.  The interface policy is misconfigured.
• B.  "out-of-service" indicates that no service graph is in use for this interface.
• C.  "out-of-service" is the default interface status in ACI.
• D.  The interface is working correctly and fully operational, but it is not in use.