Free Cisco 300-625 Exam Dumps Questions & Answers

Drag and Drop Question
Drag and drop the FLOGI parameters from the left onto the descriptions from which they were- derived on the right.

Correct Answer:

Which configuration is available only in Cisco DCNM-SAN Advanced mode?

• A.  VMpath configuration
• B.  IVR
• C.  template-based provisioning
• D.  zoning

Refer to the exhibit. The san-user must configure FSPF on the VSAN 500, but fails. An operator with network administrative rights must authorize the san-user to perform this work.
Which configuration must the operator apply?

• A.  MDS-A(config)# role name sangroup
  MDS-A(config-role)# rule 2 permit config feature vsan
• B.  MDS-A(config)# role name sangroup
  MDS-A(config-role)# no rule 2
• C.  MDS-A(config)# role name sangroup
  MDS-A(config-role)# rule 4 permit config feature fspf
• D.  MDS-A(config)# role name sangroup
  MDS-A(config-role)# vsan policy deny
  MDS-A(config-role-vsan)# permit vsan 500

Which result occurs if a device alias is renamed and then the original device alias name is used in an add command in the same session?

• A.  Both commands execute successfully.
• B.  Both commands are moved to the rejected list.
• C.  The device alias is renamed and the add command is moved to the rejected list.
• D.  The rename command is moved to the rejected list and the add command executes successfully.

Refer to the exhibit. What is the result of the configuration?

• A.  PFC fails to operate properly unless LFC is disabled on Ethernet 1/10.
• B.  PFC operates on Ethernet 1/10 regardless of the capability of the peer.
• C.  No-drop CoS values are advertised by the DCBX.
• D.  LFC is prioritized over PFC on Ethernet 1/10.