Free Cisco 350-001 Exam Dumps Questions & Answers

Multi Protocol Label Switching (MPLS) is a data-carrying mechanism that belongs to the family of packet-switched networks. For an MPLS label, if the stack bit is set to1, which option is true?

• A.  The stack bit is reserved for future use.
• B.  The stack bit is for Cisco implementations exclusively and will only be used when TDP is the label distribution protocol.
• C.  The stack bit will only be used when LDP is the label distribution protocol
• D.  The label is the last entry in the label stack.

Refer to the exhibit. Voice traffic is marked "precedence 5." How much bandwidth is allocated for voice traffic during periods of congestion?

Cisco 350-001 Exam

• A.  a maximum of 48% of the available bandwidth
• B.  a minimum of 48 kb/s
• C.  a maximum of 48 kb/s
• D.  a minimum of 48% of the available bandwidth

Refer to the exhibit. This exhibit shows the NAT configuration for Router A and the output for a ping issued from device 171.68.200.48 and destined to 172.16.47.142. Based on this information, what change must be made to Router A in order for the ping to work?

Cisco 350-001 Exam

• A.  reload the router
• B.  add a static route
• C.  clear the route cache
• D.  load a newer IOS image
• E.  configure IP as classless

Refer to the exhibit.

An EBGP session is not established between Router1 and Router2.

• A.  A static route needs to be added on Router1 and Router2.
• B.  The update-source loopback 0 command needs to be removed.
• C.  The ebgp-multihop value must be increased to 3.
• D.  Use the serial interface IP addresses in the neighbor command, but leave the update source pointing to loopback 0.

Two routers are connected by a serial link, and are configured to run EIGRP on all interfaces. You examine the EIGRP neighbor table on both routers (using the show ip eigrp neighbor command) and see that the router connected over the serial link is listed as a neighbor for a certain amount of time, but is periodically removed from the neighbor table.
None of the routes from the neighbor ever seem to be learned, and the neighbor transmission statistics (SRTT, RTO, and Q Count) seem to indicate that no packets are being transmitted between the neighbors. Which would most likely cause this problem?

• A.  While multicast packets are being successfully sent over the link, unicast packets are not
• B.  There is a bug in the EIGRP code that needs to be fixed.
• C.  This is correct behavior for the first few minutes of EIGRP neighbor formation. After four or five cycles, it should straighten itself out and the neighbor
• D.  The hello or hold intervals are set differently on the two routers.