Free Cisco 400-201 Exam Dumps Questions & Answers

Which three IS-IS TLVs floods the MPLS TE resource allocation information through the network? (Choose three)

• A.  Traffic engineering router ID
• B.  Extended IS reachability
• C.  IS TE reachability
• D.  Opaque
• E.  RSVP
• F.  Extended IP reachability

Which two IOS commands are equivalents for putting a Cisco 7500 OC-12 RPR interface card into wrapped mode? Select all that apply

• A.  srp ips request manual-switched [a | b]
• B.  srp shutdown [a | b]
• C.  shutdown [a | b]

A service provider is implementing an nV Edge system with the two ASR 9000 chassis has two RSPs. Which two cabling methods reflect the minimum configuration needed for full synchronization between the two Cisco ASR 9000 chassis? (Choose two)

• A.  Create the IRL connections between the two chassis via Layer 1 connections using the EOBC 10 Gbps ports of the RSPs
• B.  Create the IRL connections between the two chassis via Layer 1 connections using the10 Gbps ports of the line cards
• C.  Create the single virtual control plane that connect the two chassis via Layer 3 connections using the 10 Gbps ports of the line cards
• D.  Create the IRL connections between the two chassis via Layer 3 connections using the EOBC 10 Gbps ports of the RSPs
• E.  Create the single virtual control plane that connect the two chassis via 100 Gbps bundle interfaces
• F.  Create the single virtual control plane that connect the two RSPs between the two chassis via Layer 2 connections
• G.  Create the IRL connections between the two chassis via Layer 3 connections using the ports of the line cards

An ISP provides MPLS L3VPN services and is required to set up a multicast VPN. Which routers will be enabled with MDT to support a multicast VPN?

• A.  All service provider route reflectors.
• B.  All service provider P routers.
• C.  All service provider PE routers.
• D.  All service provider routers participating in the multicast VPN.
• E.  All service providers P, PE and route reflector routers.

Which statement is FALSE concerning Concatenation?

• A.  It reduces upstream data throughput.
• B.  Concatenation activity on an interface can be checked by the show controller counters command
• C.  It can be enabled/disabled from CMTS on per upstream port basis if desired
• D.  It allows ITCM to send multiple upstream packets in one single large burst.