Free Cisco 600-601 Exam Dumps Questions & Answers

At which Layer would you check ACLs for TCP ports being blocked?

• A.  Layer 1
• B.  Layer 2
• C.  Layer 4
• D.  Layer 3

A router is not operating as expected and the network administrator wants to verify that the router booted using the correct IOS image. Which command should be used to determine which IOS is running on the router?

• A.  show config-register
• B.  show startup-config
• C.  show flash
• D.  show version
• E.  show memory

At which Layer would you use trace route to validate the path?

• A.  Layer 1
• B.  Layer 2
• C.  Layer 4
• D.  Layer 3

In which two ways could you minimize the impact of monitoring an industrial network? (Choose two.)

• A.  Send random messages to a device and see what the response is.
• B.  Do frequent ping sweeps to industrial devices to check for their proper operations.
• C.  Use an industrial-network-grade IDS-IPS system.
• D.  Make a copy of all the network traffic and analyze it offline.

Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

• A.  The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.
• B.  EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.
• C.  IEEE1588 and PTP are important for ensuring real-time synchronization.
• D.  EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
• E.  CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
• F.  Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.