Free CompTIA RF0-001 Exam Dumps Questions & Answers

When using an RFID enabled printer to encode tags as they are being printed, which of the following determines the data being encoded?

• A.  The software generating the print job.
• B.  The printer's firmware.
• C.  The printer is encoding in a sequence guaranteeing unique data on each tag.
• D.  RFID enabled printers cannot encode RFID tags.

When attaching a passive ultra high frequency (UHF) tag to an asset that is made of metal, the technician would need a standoff between the tag and the metal surface:

• A.  so the tag is not detuned from the resonant frequency.
• B.  to prevent the tag from being shorted out by the metal surface.
• C.  because the magnetic properties of metals interferes with the tag transmitter.
• D.  to keep the tag cool by having an air gap between surfaces.

When installing cabling and wiring within a safety enclosure around an RFID interrogator, which of the following should be done?

• A.  Remove screws from unused terminals.
• B.  Ensure all wiring sizes are the same.
• C.  Use cable restraints only on wires greater than 8 American wire gauge (AWG).
• D.  Place wire numbers on all wires.

An organization has received a shipment of Electronic Product Code (EPC) Class 1 Gen 2 RFID tags from the manufacturer and is unable to read them with existing Class 1 interrogators. Which of the following actions should be taken FIRST?

• A.  Perform a firmware upgrade.
• B.  Replace the interrogators with updated models.
• C.  Add an EPC decoder to the middleware.
• D.  Enable dense reader mode.

If an interrogator and associated antennas are located at a dock door with a desk for the traffic coordinator, which of the following may be a concern?

• A.  The traffic coordinator may be over exposed to radio waves.
• B.  The traffic coordinator would rely too much on the RFID data.
• C.  The interrogator could not be connected to the network.
• D.  The forklift drivers would have access to the interrogator data.