Free F5 F5CAB5 Exam Dumps Questions & Answers

Refer to the exhibit. A BIG-IP Administrator creates a new Virtual Server to load balance SSH traffic. Users are unable to log on to the servers. What should the BIG-IP Administrator do to resolve the issue? (Exhibit shows a Standard Virtual Server with an HTTP profile applied).

• A.  Set HTTP Profile to None9
• B.  Set Source Address to 10.1.1.210
• C.  Set Protocol to UDP8
• D.  Set Destination Addresses/Mask to 0.0.0.0/011

The BIG-IP appliance fails to boot. The BIG-IP Administrator needs to run the End User Diagnostics (EUD) utility to collect data to send to F5 Support. Where can the BIG-IP Administrator access this utility?

• A.  Internal VLAN interface
• B.  Console Port
• C.  External VLAN interface
• D.  Management Port

Which command verifies configuration syntax?

• A.  restart sys service
• B.  show sys version
• C.  save sys config
• D.  load sys config verify

Refer to the exhibit.

A BIG-IP Administrator configured a virtual server with a pool of 3 members and selected the Round Robin load balancing method to evenly distribute traffic across the pool members. During initial testing, traffic was not evenly distributed and the pool member 172.16.20.3 received more traffic than the other pool members.
Refer to the exhibit and the virtual server configuration provided below:
Plaintext
ltm virtual http.vs {
destination 10.10.1.100:http
ip-protocol tcp
mask 255.255.255.255
persist {
source_addr { default yes }
}
pool http.pool
profiles {
tcp{}
}
serverssl-use-sni disabled
source 0.0.0.0/0
source-address-translation {
type automap
}
translate-address enabled
}
What is the most likely cause of this behavior?

• A.  Automap source address translation can cause uneven load balancing
• B.  Pool members' ratio settings are causing the uneven traffic distribution
• C.  Round Robin requires an HTTP profile to work efficiently
• D.  A persistence profile assigned to the virtual server can cause uneven load balancing

A BIG-IP Administrator configured the following virtual server to pass traffic on all addresses and ports. After configuration is completed, the BIG-IP Administrator notices that the virtual server is unable to pass traffic.
ltm virtual forwarding_any_vs {
destination 0.0.0.0:any
ip-forward
mask 255.255.255.255
profiles {
fastL4 { }
}
serverssl-use-sni disabled
source 0.0.0.0/0
translate-address disabled
translate-port disabled
}
Which part of the configuration is the cause of the issue? (Choose one answer)

• A.  Incorrect destination configured
• B.  Incorrect mask 255.255.255.255
• C.  Incorrect translate-address configured