Free HP HP2-Z30 Exam Dumps Questions & Answers

What is the initial OSPF state of a router when an interface becomes active for a segment?

• A.  init
• B.  down
• C.  loading
• D.  two-way

A network administrator acquires a new HP Comware switch from HP with the factory default settings. The network administrator logs into the console port and configures the following information:
user-interface aux0 quit super password level 0 simple hp0 super password level 1 simple hpl super password level 2 simple hp2 super password level 3 simple hp3
What happens the next time the network administrator logs into the console?

• A.  The network administrator must enter a password of hp3.
• B.  The network administrator is immediately taken to level 3 with no password prompted.
• C.  The network administrator must enter a password of hp0.
• D.  The network administrator must perform the password recovery procedure because it was incorrectly configured.

When performing auto discovery with Intelligent Management Center (IMC), which two components should be defined in order to fully manage the discovered networking devices?

• A.  SNMP and telnet
• B.  telnet and SSH
• C.  SNMP and syslog
• D.  SSH and TFTP

What is a key emerging standard protocol that HP Virtual Application Networks (VAN) use to implement Software-Defined Networks (SDN)?

• A.  FlexFabric
• B.  OpenFlow
• C.  OpenStack
• D.  IMC

What is the default state of spanning tree on HP Comware switches?

• A.  STP is disabled.
• B.  PVST is enabled.
• C.  RSTP is enabled.
• D.  MSTP is enabled.