Free HP HPE0-V15 Exam Dumps Questions & Answers

Read the question, and then refer to the exhibit.
<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?

• A.  Configure the interface as an IRF port.
• B.  Configure the PVID of the interface to be VLAN 20.
• C.  Configure the interface as an access port.
• D.  Permit VLAN 20 on the interface.

A customer with limited IT administration resources needs a complete HPE server, storage, and networking solution. The solution must be able to be deployed in an hour or less through a simple, wizard-based setup. They want to manage the HPE solution through a simple, integrated plug-in to vCenter, since their IT staff members are already familiar with vCenter.
Which HPE solution best meets the customer requirements?

• A.  HPE OneView for VMware vCenter
• B.  HPE ConvergedSystem 750
• C.  HPE Proliant for Microsoft Azure Stack
• D.  HPE Nimble Storage dHCI

You need to change BIOS configuration settings without rebooting a server.
Which system utility should you use?

• A.  Lights-Out Online Configuration utility
• B.  smart Storage Administrator
• C.  intelligent Provisioning
• D.  Intelligent Management Center

What is the process or writing data to two locations within a single array in real time?

• A.  replication
• B.  data mirroring
• C.  business continuity
• D.  clustering

A customer is moving a server from a co-location facility back into their existing data center to comply with new internal policies on data management Due to budget constraints, the customer cannot purchase any additional switches and will need to use an existing end-of-row design with HPE FlexFabric switches While the server will be installed six racks away from the switches, the total cable run with cable management Is expected to be 35 m.
Which component should be selected when designing the 10 Gbps connectivity option for the server?

• A.  QSFP+ Active Optical Cable
• B.  SFP+ 10G LC SR Transceiver
• C.  QSFP28 Active Optical Cable
• D.  SFP+ Direct Attach Copper Cable
• E.  SFP+ Active Optical Cable