Free HP HPE2-Z39 Exam Dumps Questions & Answers

A network administrator creates a route to 10.1.2.0724 on Switch-4.
What is the correct next hop for the route?

• A.  10.1.0.9
• B.  10.1.0.2
• C.  10.1.21
• D.  10.1.0.1

An Aruba Virtual Switching Framework (VSF) fabric has 10GbE interfaces assigned to its
VSF link. The network administrator wants to change the link to use 40GbE interfaces.
Which procedure follows the best practices and requirements to set up the VSF links?

• A.  Shut down the standby member, remove the VSF link, and then re-create the link with only 40GbE interfaces.
• B.  Create an LACP link aggregation on the 40GbE interfaces, and then add them to the
  VSF link.
• C.  Create a second VSF link that uses the 40GbE interfaces, and then remove the first
  VSF link.
• D.  Add the 40GbE interfaces to the VSF link, and then remove the 10GbE interfaces from the link.

Network administrators need to access an ArubaOS switch CLI remotely. How can the administrator ensure that all data passed between management stations and the switch is encrypted?

• A.  Create an SSH key. enable SSH. and disable Telnet.
• B.  Configure operator and manager passwords for Telnet access.
• C.  Enable HTTPS access.
• D.  Create local user accounts and enable command authorization.

A network administrator enters this command on an ArubaOS switch:
Switch(config) # trunk 1,2 trk1
What is required for the switch to combine both interfaces in a link aggregation?

• A.  that the interfaces are aggregated while in a shutdown state
• B.  that the interfaces are up and have LACP enabled on them
• C.  that the interfaces are up and connect to interfaces that support active mode LACP
• D.  that the interfaces are up

A network administrator suspects that interfaces in a link aggregation have been accidentally connected to multiple switches. The administrator wants to find the hostnames of the switches on the other side of the interfaces. How can the administrator find this information?

• A.  Use the show trunks command to view link aggregation information.
• B.  Use the show lace command to view LACP information.
• C.  Use the show lldp info remote-device command to view LLDP information.
• D.  Use the show interface command to view detailed interface status.