Free Juniper JN0-333 Exam Dumps Questions & Answers

You are asked to support source NAT for an application that requires that its original source port not be changed.
Which configuration would satisfy the requirement?

• A.  Configure a source NAT rule that sets the egress interface to the overload status.
• B.  Configure a source NAT rule that references an IP address pool with interface proxy ARP enabled.
• C.  Configure a source NAT rule that references an IP address pool with the port no-translation parameter enabled.
• D.  Configure the egress interface to source NAT fixed-port status.

You have recently configured an IPsec tunnel between two SRX Series devices. One of the devices is assigned an IP address using DHCP with an IP address that changes frequently. Initial testing indicates that the IPsec tunnel is not working. Troubleshooting has revealed that Phase 1 negotiations are failing.
Which two actions would solve the problem? (Choose two.)

• A.  Verify that the device with the IP address assigned by DHCP is the traffic initiator.
• B.  Verify that PKI is properly configured.
• C.  Verify that VPN monitoring is enabled.
• D.  Verify that the IKE policy is configured for aggressive mode.

Which three elements does AH provide in an IPsec implementation? (Choose three.)

• A.  authentication
• B.  confidentiality
• C.  integrity
• D.  replay attack protection
• E.  availability

What are the maximum number of supported interfaces on a vSRX hosted in a VMware environment?

• A.  4
• B.  3
• C.  10
• D.  12

Click the Exhibit button.

You notice that your SRX Series device is not blocking HTTP traffic as expected.
Referring to the exhibit, what should you do to solve the problem?

• A.  Move the deny-http policy to the bottom of the policy list.
• B.  Commit the configuration.
• C.  Configure the SRX Series device to operate in packet-based mode.
• D.  Reboot the SRX Series device.