Free Juniper JN0-347 Exam Dumps Questions & Answers

You are a service provider and have multiple customers in a building.
You are installing a new switch that can host all of your customers. However, you would like to ensure that one customer cannot see or broadcast to another customer.
You would also like to have them use a common gateway IP address from the building. What should be used to provide this access?

• A.  Layer 2 tunneling
• B.  private VLAN
• C.  VLAN
• D.  filter-based VLAN

You have deployed a Juniper EX Series switch in the network. The switch receives a broadcast frame on an interface.
Which statement describes the behavior of the switch?

• A.  The frame is re-transmitted as a multicast frame on all ports on the switch.
• B.  The frame is flooded out all ports in all VLANs configured on the switch.
• C.  The frame is flooded out all ports that are part of the same VLAN as the receiving port, except for the port on which the frame was received.
• D.  The frame is flooded out all ports that are part of the same VLAN as the receiving port, including the port on which the frame was received.

Which two statements describe the BGP Local Preference attribute? (Choose two.)

• A.  The attribute can be used to direct all outbound traffic through a specific peer.
• B.  The attribute can be altered through a BGP configuration or using a policy.
• C.  The attribute can be given a higher preference by configuring a lower numerical value.
• D.  The attribute is transmitted across EBGP links.

What are three extended BGP communities? (Choose three.)

• A.  domain-id: 192.168.1.1:555
• B.  Origin: 172.16.100.100:100
• C.  target:65000:65000
• D.  172.16.90.100:888
• E.  extend:454:350

Which three statements are correct about the voice VLAN feature? (Choose three.)

• A.  It allows you to apply independent CoS actions to data and voice packets.
• B.  It allows the access port to accept tagged voice and untagged data packets.
• C.  It must use the same VLAN ID as data traffic on a defined interface.
• D.  It allows trunk ports to accept tagged voice and untagged data packets.
• E.  It can be used with LLDP-MED to dynamically assign the VLAN ID value to IP phones.