Free Juniper JN0-351 Exam Dumps Questions & Answers

You want to enable redundancy for the EBGP peering between the two routers shown in the exhibit.
Which three actions will you perform in this scenario? (Choose three.)

• A.  Configure an MD5 peer authentication.
• B.  Configure BGP multihop.
• C.  Configure routes for the peer loopback interface IP addresses.
• D.  Configure a cluster ID.
• E.  Configure loopback interface peering.

Which statement about aggregate routes is correct?

• A.  Aggregate routes are automatically generated for all of the subnets in a routing table.
• B.  Aggregate routes are always preferred over more specific routes, even when the specific routes have a better path.
• C.  Aggregate routes can only be used for static routing but not for dynamic routing protocols.
• D.  Aggregate routes are used for advertising summarized network prefixes.

You enable persistent MAC learning on your Juniper switch. In this scenario, which statement is correct?

• A.  You can only enable persistent MAC learning on an interface in access mode.
• B.  You can only enable persistent MAC learning on an interface on which 802.1x authentication is configured.
• C.  You can enable persistent MAC learning on an interface where MAC learning is disabled.
• D.  You can enable persistent MAC learning on an interface that is part of a redundant trunk group.

Which two statements are correct about link aggregation? (Choose two.)

• A.  Member links must use the same MTU.
• B.  IP traffic is hashed using source and destination MAC addresses.
• C.  LAGs provide physical layer redundancy.
• D.  All RE-generated traffic traverses the lowest member link.

You must implement filter-based forwarding. You need to direct traffic from the 192.168.1.0/24 through vr1 and traffic from 10.210.0.128/26 through vr2.
Which configuration is correct in this scenario?

• A. 
• B. 
• C. 
• D.