Free Juniper JN0-643 Exam Dumps Questions & Answers

-- Exhibit -

-- Exhibit --
Click the Exhibit button.
You are implementing Q-in-Q tunneling to connect R1 and R2 using the configurations shown in the exhibit.
What must be changed on Switch_A to allow both Dot1q-tunneling VLANs and non-Dot1q- tunneling VLANs on the same trunk interface?

• A.  Change the Dot1q-tunneling Ethertype to 0x8100.
• B.  Change the Dot1q-tunneling Ethertype to 0x9100.
• C.  Change the Dot1q-tunneling Ethertype to 0x98a8.
• D.  Change the Dot1q-tunneling Ethertype to 0x88a8.

Referring to the exhibit, which two actions would solve this problem? (Choose two)

• A.  set the BGP group type to internal
• B.  set the BGP group peer -AA to 65501
• C.  set the BGP group peer AA to 65502
• D.  set the BGP group discussion to internal

You enable the captive portal authentication method on your juniper switch. There is no guest-Vlan configured in this scenario what will happen when the RADIUS server fails to respond?

• A.  Access will be allow to only VLAN 4096
• B.  All access will be allowed
• C.  Access will be allowed to only VLAN 1
• D.  Access will not be allowed to any VLAN

Which two statements are true about SSM implementations on Junos devices? (Choose two.)

• A.  ASM and SSM implementations can coexist in the same network.
• B.  SSM traffic must use the 232/8 range.
• C.  There is no need for an RP.
• D.  The multicast receiver's DR must have IGMPv3 enabled.

Refer to the exhibit, which two statements are true? (Choose two)

• A.  The 192 168 2 1 peer initiated the BGP session with the local router
• B.  The local router initiated the BGP session for the 192 168 2 1 pegP
• C.  The local router initiated the BGP session for the 192 168 1 peer
• D.  The 192 168 6 1 peer initiated the BGP session with the local router