Free Juniper JN0-647 Exam Dumps Questions & Answers

Click the Exhibit.


You have just configured on an OSPF adjacency between two routers. After you commit the configuration, you notice that your adjacency is not up.
Referring to the exhibit, what would cause the problem?

• A.  You must configure bfd on R2.
• B.  You must configure lo0 on R2.
• C.  You must configure hello and dead intervals on R1.
• D.  You must configure on interface-type on R2.

You have certainly implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communicate with the appropriate community devices connected to AS-2.
What must be done to allow these community devices to communicate?

• A.  You must configure an isolation VLAN ID under the VLAN 200 ON both switches
• B.  switch You must configure the ge-0/0/10 interface on AS1 AS THE VPLAN on both switches
• C.  You must configure an isolation VLAN ID Under the pvlan-200 on the AS2
• D.  You must configure the ge-0/012 interface on both switches as P VLAN trunks

Which three statements are true about strict-high priority queues? (Choose three.)

• A.  In systems that support multiple strict-high priority queues, traffic in the strict-high queue is processed in a round-robin fashion.
• B.  In systems that support strict-high and high priority queues, traffic in the strict-high queue is completely emptied, and then high priority queue traffic is processed.
• C.  When a strict-high queue goes into negative credits, it will maintain a strict DSCP marking.
• D.  When a strict-high queue can never go into negative credits and will always transmit the traffic in the queue.
• E.  In systems that support strict-high and high priority queues, traffic in these two priorities is processed in a round-robin fashion.

You are configuring a scheduler map on an EX9200 Series device.
You want to ensure that traffic is dropped in a policing action once traffic exceeds the configured transit rate.
Which configuration parameter will meet this requirement?

• A.  percent
• B.  rate-limit
• C.  remainder
• D.  exact

Which two statements about MVRP are correct? (Choose two.)

• A.  MVRP is enabled by adding trunk ports under the [edit protocols mvrp] hierarchy.
• B.  MVRP PDUs are sent to other switches as periodic intervals.
• C.  MVRP monitors interfaces using VSTP and dynamically creates VLANs as necessary
• D.  MVRP can propagate dynamic VLANs created on one switch to another switch