Free Juniper JN0-690 Exam Dumps Questions & Answers

Which route would a packet destined to 192.168.14. take?

• A.  192.168.14.0/24 *[BGP/200]
• B.  192.168.14.0/24 *[BGP/100]
• C.  192.168.14.0/24 *[BGP/70]
• D.  192.168.64.0/21 *[Direct/0]

An interface on your Junos device reports a device-level flag of Loopback-detected.
What is causing this flag to be reported?

• A.  The link-layer protocol failed to successfully connect with the remote endpoint.
• B.  The interface was administratively disabled.
• C.  The interface is in promiscuous mode and sees frames addressed to all physical addresses on the medium.
• D.  The interface link layer received its own frames.

Click the Exhibit button.
-- Exhibit -user@r2# run show route 100.1.1.0/24 detail
inet.0: 5 destinations, 5 routes (5 active, 0 holddown, 0 hidden)
100.1.1.0/24 (1 entry, 1 announced) *Static PreferencE. 5 Next hop typE. Reject Address: 0x8f7b5a4 Next-hop reference count: 2 StatE. Local AS: 65001 AgE. 59 Task: RT Announcement bits (1): 2-KRT AS path: 65005 I
user@r2# show protocols bgp
group ibgp { type external; export to-bgp; neighbor 10.1.2.1 { local-address 10.1.2.2; family inet { unicast; } family inet6 { unicast; } peer-as 65005; }
}
user@r2# run show bgp summary Groups: 1 Peers: 1 Down peers: 0 Table Tot Paths Act Paths Suppressed History Damp State Pending inet6.0
0 0 0 0 0 0 inet.0 0 0 0 0 0 0 Peer AS InPkt OutPkt OutQ Flaps Last Up/Dwn State|#Active/Received/Accepted/Damped...
10.1.2.1 65005 31 31 0 0 12:08 Establ inet6.0: 0/0/0/0 inet.0: 0/0/0/
user@r2# show policy-options
policy-statement to-bgp { from protocol static; then accept;
}
user@r2# run show route advertising-protocol bgp 10.1.2.1
[edit] user@r2# -- Exhibit -
Referring to the exhibit, router r2 does not advertise the static route to peer 10.1.2.1. What is the problem?

• A.  An AS path loop is detected.
• B.  The static route has Next hop typE. Reject.
• C.  The export policy is incorrect.
• D.  The export policy should be applied under the [edit protocols bgp group ibgp neighbor 10.1.2.1] hierarchy.

Click the Exhibit button.
-- Exhibit -
Slot 0 information: State Online Total CPU DRAM ---- CPU less FPC ---Start time 2012-07-07 03:21:00 UTC Uptime 27 minutes, 51 seconds Slot 1 information: State Present Reason --- Hardware Not In Right Slot --Slot 2 information: State Online Total CPU DRAM 32 MB Start time 2012-07-07 03:20:59 UTC Uptime 27 minutes, 52 seconds Slot 3 information: State Present Reason --- Hardware Not Supported --Total CPU DRAM 0 MB Slot 6 information: State Online Total CPU DRAM 32 MB Start time 2012-07-07 03:21:01 UTC Uptime 27 minutes, 50 seconds
-- Exhibit -
Referring to the exhibit, which three statements are true? (Choose three.)

• A.  The card in slot 3 is not supported by the chassis.
• B.  The Control Board in slot 0 has a missing CPU.
• C.  The Flexible PIC Concentrator (FPC) in slot 1 is not installed properly for this chassis.
• D.  The Control Board in slot 6 is online and working.
• E.  The Flexible PIC Concentrator (FPC) in slot 6 is online and working.

Click the Exhibit button.
-- Exhibit -user@R1> show route 2.2.2.2
user@R1> show route forwarding-table destination 2.2.2.2
Routing table: default.inet Internet: Destination Type RtRef Next hop Type Index NhRef Netif 2.2.2.2/32 user 1 17.1.1.2 ucst 642 9 xe-1/1/0.0
-- Exhibit -
Referring to the exhibit, which statement is true about transit traffic sent to 2.2.2.2?

• A.  R1 will reject the packet.
• B.  R1 will discard the packet.
• C.  R1 will forward the packet.
• D.  R1 will redirect the packet to the Routing Engine.