Free Juniper JN0-694 Exam Dumps Questions & Answers

-- Exhibit - -- Exhibit -

Click the Exhibit button.
On R1, the interface fe-0/0/1 is assigned to the default routing instance and fe-0/0/2 is assigned to a virtual router instance named VR-1.
Referring to the exhibit, the static route 200.200.200.200/32 is missing from the routing table of the default routing instance.
What should you do on R1 to resolve this problem?

• A.  Configure an import policy to import the route 200.200.200.200/32 to the VR-1 instance.
• B.  Change the instance type on VR-1 to forwarding.
• C.  Configure a static ARP entry for address 70.1.1.1.
• D.  Create a RIB group to import the direct route 70.1.1.0/24 to both the default instance and the VR-1 instance.

Your Layer 2 network uses VLAN IDs 100 through 400 and you are required to load-balance these VLANs between two different root bridges. You are currently using the default RSTP settings and notice that all VLANs are using the same root bridge.
How do you ensure the VLANs are load-balanced between two root bridges?

• A.  Configure STP and RSTP and split the VLAN range between them.
• B.  Configure MSTP with two MSTI regions and split the VLAN range between them.
• C.  Configure two RSTP instances and split the VLAN range between them.
• D.  Configure VSTP with two VLAN groups and split the VLAN range between them.

Two neighboring routers are able to form an OSPF adjacency, but are not able to establish an IBGP neighborship.
What are two reasons for the IBGP neighborship problem? (Choose two.)

• A.  A firewall filter on one of the interfaces is blocking TCP traffic.
• B.  One of the devices has a misconfigured BGP peer address.
• C.  One or both of the connected interfaces are missing the family iso statement.
• D.  OSPF has a lower route preference than BGP.

You want to receive routes from a remote EBGP peer as shown in the exhibit. The remote site has the same AS number as your own. You have successfully established the EBGP peering, but are not receiving any routes.
Which BGP group configuration parameter will enable you to receive routes from the remote EBGP peer?

• A.  as-override
• B.  advertise-inactive
• C.  remove-private
• D.  multipath

Interface ge-0/0/12 on Switch1 is connected to ge-0/0/12 on Switch2. You have configured both Switch1 and Switch2 to run MSTP. You see the CLI output shown in the exhibit.

What would cause this output?

• A.  Switch1 and Switch2 are configured with different bridge priorities.
• B.  Switch1 and Switch2 are configured with different revision levels.
• C.  Switch1 and Switch2 are configured with different names for their VLANs.
• D.  Switch1 and Switch2 are configured with different autonomous systems.