Free Network Appliance NS0-158 Exam Dumps Questions & Answers

Click the Exhibit button.

You manage a multi-tenant NetApp storage system. You start configuring an SVM for a new customer and receive the error shown in the exhibit when you attempt to create a LIF.
You verify that the IP address is correct and that the customer LIF does not already exist.
However, you see that another customer is using the same IP address in their SVM.
How would you correct this problem?

• A.  Create a new VLAN for the new customer.
• B.  Create the LIF with a different IP address.
• C.  Create an IPspace for the new customer.
• D.  Create a broadcast domain for the new customer.

Click the Exhibit button.

You create a volume as shown in the exhibit.
Which statement about the new volume is true?

• A.  A FlexVol volume is created on the aggregate (sas_01 or sas_02) with the most free space.
• B.  A FlexVol volume is created on aggregate sas_01 can only be moved to aggregate sas_02.
• C.  A FlexGroup volume is created with eight constituents.
• D.  A FlexGroup volume is created with two constituents

What are the two valid settings for fractional reserve? (Choose two.)

• A.  0%
• B.  100%
• C.  50%
• D.  20%

Click the exhibit button.

Referring to the exhibit, which statement about the volume move process is true?

• A.  The initial replication phase sent 39 MB from the source to the destination location.
• B.  The cutover process failed and is in a holding pattern before being attempted again.
• C.  Client access is being redirected to the destination location during this phase of the operation.
• D.  Client access to the volume is blocked during this phase of operation.

A customer wants to use a UTA2 PCIe card in a new FAS8000 system.
Which three steps must be completed before the customer is able to use the ports for Fc access to an FCP switch? (Choose three.)

• A.  Verify that Data ONTAP iSCSI, GIFS, and NFS are licensed on the system.
• B.  Use the system hardware unified-connect modify command to change the personality from initiator to target.
• C.  Verify the card's hardware configuration by running the systemhardware unified-connect show command.
• D.  Verify the WWPN of the UTA2 so that these can be used in the igroup to map the LUNs for host access.
• E.  Verify that the correct SFP+ is installed for FC.