Free Network Appliance NS0-181 Exam Dumps Questions & Answers

You are planning to install a new ONTAP system for a customer.
Which action should be performed before configuring the cluster interconnect switches?

• A.  Download the software for the Fiber Channel switches before configuring them.
• B.  Use the Inventory Collect Tool before configuring the switches.
• C.  Use the Config Builder Tool to verify compatibility before configuring the switches.
• D.  Confirm the IP address and configuration information before configuring the switch

You have a 2-node switchless cluster named clusterA. You are planning on adding two additional nodes to clusterA.
What must you consider before you add the addiHonal nodes to clusterA?

• A.  Convert clusterA to a single-node cluster.
• B.  Use direct connect to add the additional nodes to clusterA.
• C.  Convert clusterA to a switched cluster by migrating the data lIFs from direct connect to die cluster interconnect switch.
• D.  Convert clusterA to a switch** cluster by migrating the cluster LIFs from direct connect to the cluster interconnect switch.

You have a 2-node switchless cluster in a remote location. Node1 has taken over node 2. You want to access node 2 to investigate the problem.
In this scenario, how would you contact node 2 from a remote location?

• A.  Use telnet to access the Service Processor IP on node 2.
• B.  Use SSH to access the node management IP on node 1.
• C.  Use SSH to access the node management IP on node 2.
• D.  Use SSH to access the Service Processor on node 2.

Select the Exhibit tab.

The exhibit illustrates the network cabling of a 4-node HA cluster that includes four separate networks.
Which two definitions are correct in this scenario? (Choose two.)

• A.  A cluster can be created without data network connections, but it must include a cluster interconnect connection.
• B.  A cluster cannot be created without data network connections, but it must include a cluster interconnect connection.
• C.  Each node may be connected to the management and cluster networks only.
• D.  Each node must be connected to five distinct networks.

A customer has recently purchase a new ONTAP 9.0 storage system and wants you to join the nodes to an existing cluster running ONTAP 9.1.
What is the first step for adding the new controllers to the existing cluster?

• A.  You must make sure that there Is the same amount of disk shelves attached to all nodes.
• B.  You must match the operating system.
• C.  You must ensure that all network switches are upgraded and online.
• D.  You must configure the existing cluster to accept the Joining nodes.