Free Nutanix NCSC-Level-1 Exam Dumps Questions & Answers

A consultant configures a Nutanix cluster and integrates the hosts into vCenter using VMware best practices. The customer has requested that the Nutanix cluster only have a single datastore.
Upon configuring the cluster per the customer requirements, vCenter displays an alert regarding the heartbeat datastore. The consultant adds the das.ignoreInsufficientHbDatastore value = true rule. The container can be seen from each host, but the alert remains active.
What should the consultant do to resolve this issue?

• A.  Make sure the DRS setting is turned on.
• B.  Turn off and then turn back on HA.
• C.  Create a second container.
• D.  Whitelist the vCenter IP address within Prism.

A consultant is planning an installation and needs to collect configuration items to be used during the install. The data needed from the customer are IP addresses, Gateway, DNS servers, and NTP Servers.
Which Cluster Deployment document must be completed with the customer?

• A.  Operations Guide
• B.  Project Plan
• C.  Technical Checklist
• D.  Questionnaire

Where can a consultant find Nutanix Enablement Starter Packs (ESPs)?

• A.  In the Partner Portal
• B.  In the Nutanix .NEXT Community Forum
• C.  In the Services section of the Nutanix website.
• D.  In the Support Portal

A consultant is using a customer's switch for installation. Although the 10GbE ports for each of the hosts are connected to the switch, the nodes fail to be discovered.
What is causing the issue?

• A.  10GbE ports are configured with the incorrect duplex setting.
• B.  Foundation VM is running on a Windows host.
• C.  IPv6 is not enabled on the switch.
• D.  IPMI port is not plugged in.

A consultant needs to review a customer's switch port configuration to identify any issues. Other customer requirements are as follows:
* Leverage LACP
* Native VLAN will not be used
* Use Multiple Upstream switches
* Use VLANs 20-25 and 30
* LACP Fallback has been Enabled
* vPC or MLAG has been configured
What must be included in a configuration in order to meet these requirements?

• A.  Native VLAN set to default
  Ports trucked to allow all necessary VLANs
• B.  Native VLAN set to 30
  Ports in access mode to allow all necessary VLANs
• C.  Native VLAN set to default
  Ports in access mode to allow all necessary VLANs
• D.  Native VLAN set to 30
  Ports Trunked to allow all necessary VLANs