Join the discussion
Question 1/88
An analytical tool that organizes and characterizes potential accidents in a logical and graphical manner
Correct Answer: D
Add Comments
- Other Question (88q)
- Q1. An analytical tool that organizes and characterizes potential accidents in a logical and g...
- Q2. The suitability and current condition of the equipment within the current operating envelo...
- Q3. ______________ provides a consistent methodology for assessing the optimum combination of ...
- Q4. Coordinated activities to direct and control an organization with regard to risk....
- Q5. The reduction in the ability of a component to provide its intended purpose of containment...
- Q6. The type of failure mode that likely to occur due to pitting...
- Q7. Loss of containment is
- Q8. _________ are the primary inputs into the probability of failure evaluation....
- Q9. Risk presented in qualitative risk analysis as...
- Q10. Reliability efforts, such as reliability centered maintenance (REM), can be linked with RB...
- Q11. In RBI program discrimination between equipment items on the basis of significance of pote...
- Q12. _________________curves are referred for the deterioration mechanism for carbon and low al...
- Q13. Who should be consulted to define the equipment deterioration mechanisms, susceptibility a...
- Q14. The primary audience for RP 580 is
- Q15. ______________ delineate initiating events and combinations of system...
- Q16. RBI is based on
- Q17. Risk presented in quantitative risk analysis as a...
- Q18. In RBI most of the probability assessment will be...
- Q19. Probability side of the risk equation is normally managed by...
- Q20. When in accurate or insufficient failure data exists on the specific equipment item for qu...
- Q21. ___________ is usually not the primary objective of a RBI assessment, but it is frequently...
- Q22. In jurisdictions that permit the application of the API Inspection Codes and standards...
- Q23. _________________curves are referred for the deterioration mechanism for carbon and low al...
- Q24. If a very aggressive acid is carried over from a corrosion resistant part of a system into...
- Q25. In general, the probability of failure is determined by...
- Q26. Hazard identification in a rbi analysis generally focuses on identifiable failure mechanis...
- Q27. Following are some of the recognized risks which cannot be managed by inspection alone exc...
- Q28. The type of failure mode that likely to occur due to mechanical and metallurgical deterior...
- Q29. Results of quantitative consequence analysis are usually expressed in...
- Q30. Some failures have potentially serious consequences, but if the probability of the inciden...
- Q31. The type of failure mode that likely to occur due thinning...
- Q32. The primary audience for rp 580 is
- Q33. Limitation of any negative consequence or reduction in probability of a particular event...
- Q34. Risk presented in qualitative risk analysis as...
- Q35. ........Is not a substitute for a process hazards analysis (pha) or hazop...
- Q36. Who can provide useful input (such as the spectrum of process conditions, injection points...
- Q37. Following are the non-inspection mitigation actions except one...
- Q38. Thing or activity with a potential for con- sequence...
- Q39. Systematic use of information to identify sources and to estimate the risk...
- Q40. Consequence side of the risk equation is normally managed by...
- Q41. In the event of a leak the potential failure of an isolation valve could...
- Q42. Following are some of the recognized risks which cannot be managed by inspection alone exc...
- Q43. __________ is not a substitute for a process hazards analysis (PHA) or HAZOP...
- Q44. ________________may result in the calculated corrosion rate appearingartificially high or ...
- Q45. Failure mode can primarily affects the
- Q46. The ability to state the rate of deterioration precisely is affected by the following exce...
- Q47. CORRECT TEXT Rp 580 significantly targeted at the application of rbi in the..................
- Q48. Probability of failure analysis is made from
- Q49. ________________ may result in the calculated corrosion rate appearing artificially high o...
- Q50. Combination of the probabilityof an event and its consequence...
- Q51. Is key to performing deterioration mechanism identification...
- Q52. Equipment reliability is especially important if leaks can be caused by...
- Q53. Act of mitigating a known risk to a lower level of risk....
- Q54. FILL BLANK RBI as an integrated management tool that complements___________...
- Q55. Limitation of any negative consequence or reduction in probability of a particular event...
- Q56. The probability of failure, when coupled with theassociated consequenceof failure (cof)(se...
- Q57. _____________ represents the next generation of inspection approaches and interval setting...
- Q58. Following are the common mechanical deterioration mechanisms except...
- Q59. ____________ uses logic models depicting combinations of events...
- Q60. For a typical inspection program, if excessive inspection is applied then,...
- Q61. A process to assess risks, to determine if risk reduction is required and to develop a pla...
- Q62. Process to find, list, and characterize elements of risk...
- Q63. Following are the critical variables for deterioration mechanism except...
- Q64. The data validation step stresses the need for a knowledgeable individual....
- Q65. Thing or activity with a potential for con- sequence...
- Q66. If operating condition have changed, deterioration rates based on inspection data from the...
- Q67. ____________ areoftennecessary to establish susceptibility ofequipment to stress corrosion...
- Q68. Potential source of errors in rbi analysis regarding data quality are the following except...
- Q69. Provides a basis for risk evaluation, risk mitigation and risk acceptance...
- Q70. When the inspection program is optimized based on an understanding of risk, one or more of...
- Q71. Following will cover the functional failures except...
- Q72. Thinning causes the loss of material from
- Q73. Other functional failures are usually covered within...
- Q74. Equipment reliability is especially important if leaks can be caused by...
- Q75. The rbi program for environmental consequences, typically focuses...
- Q76. Rbi is based on
- Q77. If the material of construction and internal/external conditions are the same...
- Q78. The type of failure mode that likely to occur due to ssc...
- Q79. Results from quantitative analysis logic models are validated by...
- Q80. CORRECT TEXT Rbi as an integrated management tool that complements....
- Q81. Deterioration for specific process equipment is not available, this can be sourced from...
- Q82. Risk presented in quantitative risk analysis as a...
- Q83. In most consequence evaluations, a key element in deter-mining the magnitude of the conseq...
- Q84. ____________deals with total risk than with risk involve only with the equipment....
- Q85. Rbi is focused on a systematic determination of...
- Q86. Some failures have potentially serious consequences, but if the probabilityof the incident...
- Q87. The amount and type of codes and standards used by a facility can have...
- Q88. If multiple inspections have been performed, which inspection may best reflect current ope...
