1. Home
  2. Autodesk
  3. Autodesk Certified Professional: AutoCAD for Drafting and Design
  4. Autodesk.ACP-01101.v2023-12-05.q16
  5. Question 1

Join the discussion

Question 1/16

When you create an attribute definition, which mode should be used if you want the default value of the attribute assigned upon insertion where the attribute value cannot be changed?
Note Exhibit shown is the AutoCAD interface in Windows While the AutoCAD for Mac version differs in appearance, the correct answer correlates in the options.

Add Comments

Your email address will not be published. Required fields are marked *

insert code
Type the characters from the picture.
Other Question (16q)
Q1. When you create an attribute definition, which mode should be used if you want the default...
Q2. You have a simple polyline selected that consists of li Select whether each statement is T...
Q3. Move three applicable commands from the list on the left to the corresponding function on ...
Q4. Exhibit (Exhibit) This image needs to be reproduced in AutoCAD. The wall and plaster lines...
Q5. You have two viewports at different viewport scales as shown in the exhibit. The geometry ...
Q6. Move three applicable xref options from the list on the left to the corresponding function...
Q7. In model space (MODEL), a room label text height is set to 300 mm in the designated text s...
Q8. You need to create a hatch pattern that looks the same regardless of the viewport scale. W...
Q9. You place a red rectangular polyline over a PDF underlay in a drawing, and then use the re...
Q10. Refer to the exhibit. (Exhibit) You are working on a drawing. You copy a set of entities a...
Q11. With an associative array selected as shown in the exhibit, which command will separate th...
Q12. You have three multileaders as shown in exhibit 1. (Refer to the exhibit 1 tab.) (Exhibit)...
Q13. What should be typed at the command line in order to start creating a line for drawing ref...
Q14. (Exhibit) You have a line segment that is 150 units long as shown in the exhibit. You need...
Q15. You need to snap to the centroid of a closed polyline. Which Object Snap mode should you u...
Q16. In the Layer Properties Manager, which column should you use to prevent a layer from being...