Join the discussion
Question 1/75
A customer is monitoring an existing HPE 3PAR array, which is doing synchronous replication to a remote site. The customer notices that controller utilization regularly exceeds 60% on all nodes. An HPE 3AR OS upgrade to 3.3.1 MU2 is planned in the near future to support compression on the array.
What should you inform the customer before performing the upgrade?
What should you inform the customer before performing the upgrade?
Correct Answer: A
Add Comments
- Other Question (75q)
- Q1. A customer is monitoring an existing HPE 3PAR array, which is doing synchronous replicatio...
- Q2. A customer is interested in using HPE InfoSight Cross-stack Analytics for VMware. Where do...
- Q3. A customer attempts to test HPE 3PAR Peer Persistence automated failover by disconnecting ...
- Q4. A customer needs to analyze performance and capacity of their storage environment. Their e...
- Q5. A customer has a requirement to provide disaster recovery for an application. The applicat...
- Q6. A customer needs to setup specific replication bandwidth requirements to limit the bandwid...
- Q7. A customer needs to replicate the data on their HPE 3PAR arrays between their datacenters....
- Q8. Match the HPE resource to Its source location. (Exhibit)...
- Q9. A customer has a requirement to provide disaster recovery for an application. The applicat...
- Q10. A customer needs to upgrade their existing HPE 3PAR environment. They ask you to present a...
- Q11. A customer has a solution from another vendor. The customer ran into issues of a dispropor...
- Q12. You have chosen to utilize HPE 3PAR synchronous replication in order to meet the customer ...
- Q13. A customer requests a proposal for two HPE 3PAR arrays using asynchronous periodic replica...
- Q14. A customer has started to load their HPE 3PAR 8450 with data, but are not sure what data r...
- Q15. A customer configured the RCIP ports on two HPE 3PAR arrays, and cabled them to the respec...
- Q16. Refer to the exhibit. (Exhibit) A customer has the environment shown. They currently perfo...
- Q17. A customer needs to replicate data from a single HPE 3PAR source array to multiple HPE SPA...
- Q18. A customer has a pair of HPE 3PAR arrays with Synchronous Replication enabled. They need r...
- Q19. A customer has a primary site with an HPE Nimble Storage array and a secondary site with a...
- Q20. A customer wants to convert all of the virtual volumes on an HPE 3PAR 8460 from RAID 5 to ...
- Q21. You completed the HPE Nimble storage replication partnership in a customer environment. Wh...
- Q22. A customer has two HPE Nimble arrays that are replication partners. The replication schedu...
- Q23. A customer has an HPE 3PAR 7400 running 3.2.1 MUG with 64 drives using the original licens...
- Q24. You are comparing Nimble features with other vendors. What should you point out to a custo...
- Q25. You are designing a multi-site replication solution using HPE 3PAR storage array. Which ke...
- Q26. A customer needs to upgrade their existing HPE 3PAR environment. They ask you to present a...
- Q27. A customer has two HPE SPAR arrays with synchronous replication configured. I he customer ...
- Q28. You receive an error when attempting to utilize SAF Analyze to upload customer data that y...
- Q29. A customer has a requirement to provide Disaster Recovery for an application that is very ...
- Q30. You are proposing a replication solution to a customer. A competitor offers a solution bas...
- Q31. A customer wants to enable an automated failover for their two existing HPE 3PAR solutions...
- Q32. A customer needs to replace their outdated storage arrays. Which resource provides the nec...
- Q33. A customer has two sites. The link between sites is Fibre Channel, and the distance betwee...
- Q34. A customer wants to replace an EMC storage array. You want to provide as much Information ...
- Q35. Refer to the exhibit, which reflects the Bill of Materials (BOM) configuration for one dat...
- Q36. A customer has a requirement to provide disaster recovery for an application. The applicat...
- Q37. Click and drag the steps on the left into the appropriate order on the right to set up an ...
- Q38. What must be considered Alien denning a data compliance strategy?...
- Q39. Match the HPE Storage tool to its functionality. (Exhibit)...
- Q40. Refer to the exhibit. (Exhibit) A customer requests a solution for two 3PAR 8450 storage a...
- Q41. A customer has a pair of HPE 3PAR arrays with Synchronous Replication enabled. They need r...
- Q42. A customer experiences a performance issues and blames the HPE 3PAR array. However, you su...
- Q43. Refer to the exhibit. A customer is looking to replace the backup environment shown. Which...
- Q44. Refer to the exhibit. (Exhibit) A customer asks you to design an HPE 3PAR 9450 solution wi...
- Q45. A customer has recently acquired another company that is located less than 3 km from their...
- Q46. A customer requires an all-flash solution that will scale out, with multiple arrays for re...
- Q47. A customer uses HPE Nimble storage with replication in a VMware environment. The customer ...
- Q48. Which HPE 3PAR functionality allows addition of data located on non-HPE storage systems to...
- Q49. Refer to the exhibit. (Exhibit) A customer has the environment shown. They currently perfo...
- Q50. A customer's primary and OR datacenter are over 700 km apart. The customer wants to minimi...
- Q51. A customer requires an all-flash solution that will scale out, with multiple arrays for re...
- Q52. A customer requires a 5 PB object storage solution across two sites. Which storage solutio...
- Q53. You are discussing a HPE 3PAR Remote Copy solution with your customer. The customer has ha...
- Q54. Which advantage does InfoSight for HPE Storage deliver to a customer?...
- Q55. A customer needs the absolute best protection against ransomware. Which solution meets the...
- Q56. A customer attempts to test HPE 3PAR Peer Persistence automated failover by disconnecting ...
- Q57. Refer to the exhibit. (Exhibit) A customer is planning a new compute cluster. They require...
- Q58. You are starting an assessment to design a new multi-storage environment for a customer. Y...
- Q59. A customer needs to replace outdated storage arrays. Which resource provides the necessary...
- Q60. A customer wants to enable an automated failover for their two existing HPE 3PAR solutions...
- Q61. For customers, what are the benefits of developing a company compliance policy? (Select tw...
- Q62. A customer needs to upgrade their existing HPE 3PAR environment. They ask you to present a...
- Q63. Which advantage does InfoSight for HPE Storage deliver to a customer?...
- Q64. Refer to the Exhibit. (Exhibit) A customer with an existing HPE Nimble installation sends ...
- Q65. A customer recently acquired another company located less than three km from their current...
- Q66. A customer has standardized on Windows Server. They need to ensure that application and st...
- Q67. A customer needs to replicate multiple HPE 3PAR source arrays to a single HPE 3PAR target ...
- Q68. A customer configured the RCIP ports on two HPE 3PAR arrays, and cabled them to the respec...
- Q69. You are proposing a replication solution to a customer. A competitor offers a solution bas...
- Q70. During an HPE 3PAR Remote Copy solution presentation, the customer expresses concern about...
- Q71. A customer asks you to design a solution to protect their existing ERP solution. The solut...
- Q72. Exhibit. (Exhibit) Based on the environment shown, what should you add to make the environ...
- Q73. A customer wants to upgrade an existing HPE 3PAR 7000 running HPE 3PAR OS 3.2.2. The custo...
- Q74. A customer wants to upgrade an existing HPE 3PAR 7000 running HPE 3PAR OS 3.2.2. The custo...
- Q75. Refer to the exhibit. (Exhibit) A customer is considering a new HPE 3PAR for the purpose o...
