Join the discussion
Question 1/121
The configuration information of a router is shown in the figure. Which of the following statements are correct? (Multiple choice)
Correct Answer: B,C
Add Comments
- Other Question (121q)
- Q1. The configuration information of a router is shown in the figure. Which of the following s...
- Q2. What is the main function of the dynamic routing protocol?...
- Q3. ip route-static 10.0.2.2 255.255.255.255 10.0.12.2 preference 20. Which is correct about t...
- Q4. On the broadcast network, both DR and BDR use the multicast address 224.0.0.6 to receive l...
- Q5. Which of the following types does IPv6 address contain?...
- Q6. When the router is powered on, it will read the configuration file from the default storag...
- Q7. Which of the following descriptions about firewalls is wrong?...
- Q8. In the configuration BPDU sent by the switch, which bridge ID is unlikely to appear?...
- Q9. In the CAPWAP tunnel establishment phase, after the AC receives the Join Request message s...
- Q10. When the switch port receives a data frame that does not carry VLAN TAG, it must add PVID...
- Q11. What kind of message does the OSPF protocol use to send LSA to neighbors?...
- Q12. The wireless access controller (AC, Access Cntroller) is the unified management and contro...
- Q13. If the network address of a network is 10.1.1.0/30, what is its broadcast address?...
- Q14. What kind of message does the OSPF protocol use to discover and maintain neighbor relation...
- Q15. UDP cannot guarantee the reliability of data transmission, and does not provide the functi...
- Q16. Broadly speaking, which of the following does the transmission medium that constitutes the...
- Q17. The information shown in the figure is the port status information displayed on a switch r...
- Q18. The output information of a switch is shown in the figure. Which of the following interfac...
- Q19. Which of the following statements about the S field in the MPLS packet header are correct?...
- Q20. Trunk ports can allow multiple VLANs to pass, including VLAN4096....
- Q21. The network administrator hopes to effectively use the IP address of the 192.168.176.0/25 ...
- Q22. A company applies for a Class C address segment, which needs to be evenly distributed to 8...
- Q23. vty configuration as shown in the figure, the user authority level is set to level 3. [Hua...
- Q24. Which of the following messages is used by AP to request software version from AC?...
- Q25. In order to join the wireless network STA needs to obtain wireless network information fir...
- Q26. On the VRP platform, what is the role of the command "interface vlanit <vlan-id>" ?...
- Q27. In the network shown in the figure, which of the following description is correct? (Exhibi...
- Q28. A device has been configured to complete the Telnet configuration. The device login addres...
- Q29. In which of the following network types does the OSPF protocol need to elect DR and BDR? (...
- Q30. The router needs to modify the destination IP address in the data packet when forwarding d...
- Q31. On the AC, you can manually specify the source address or source interface of the CAPWAP t...
- Q32. All ports on the root bridge switch are designated ports....
- Q33. Which of the following networks belong to a local area network? (Multiple choice)...
- Q34. As shown in the figure, the switch runs STP with default parameters, which of the followin...
- Q35. In the broadcast network as shown in the figure, OSPF runs on four routers in the same are...
- Q36. What type of IPv6 address FE80: 2E0: FCFF: FE6F: 4F36 belongs to?...
- Q37. What are the advantages of the OSPF protocol? (Multiple Choice)...
- Q38. By default, in the SNMP protocol, which port number does the agent process use to send ala...
- Q39. On interfaces that use PPP as the data link layer protocol, you can configure static route...
- Q40. The device port running STP protocol is in Forwarding state. Which of the following statem...
- Q41. MIB (Management Information Base) is a virtual database that exists only in NMS....
- Q42. As shown in the figure below, host A and host B cannot communicate. (Exhibit)...
- Q43. How many more bytes are the packets using MPLS label double-layer nesting technology than ...
- Q44. The IPv6 protocol uses NS and NA packets for duplicate address detection (DAD)....
- Q45. Which planes of the following does a network device have? (Multiple choice)...
- Q46. A certain ACL of the router is in the following rules, rule deny source 192.168.2.0 0.0.0....
- Q47. If the Proto of a route information in the routing table is OSPF, the priority of this rou...
- Q48. Regarding the IPv6 address 2031:0000:720C:0000:0000:09E0:839A:130B, which of the following...
- Q49. What address does 192.168.1.127/25 represent?
- Q50. How many types of OSPF messages are there?
- Q51. What is the number range of the Layer 2 ACL?
- Q52. Which of the following IEEE 802.11 standards support operation in the 5GHz frequency band?...
- Q53. As shown in the figure below, the wrong statement is: (Exhibit) acl number 2000] rule 5 de...
- Q54. If the application layer protocol is Te1net, what is the value of the Protoco1 field in th...
- Q55. In the network shown in the figure below, which of the following commands can be entered o...
- Q56. What are the characteristics of VLAN based on port?...
- Q57. The network shown in the figure below. The administrator hopes that RTA uses static routin...
- Q58. To apply the ACL configured in the figure in Telnet, which of the following statements is ...
- Q59. Before the STA associates with the AP, it needs to exchange some messages to obtain the SS...
- Q60. As shown in the figure below, router A has Telnet router B through IP address 10.0.12.2. I...
- Q61. Which of the following IEEE802.11 standards only supports 2.4GHz frequency band for commun...
- Q62. After the administrator successfully logs in to the router through Telnet, and finds that ...
- Q63. FAT AP can independently complete wireless user access, wireless user authentication, and ...
- Q64. For multiple paths to the same destination network, the router needs to select by comparin...
- Q65. The broadcast address is a special address in which the host bits in the network address a...
- Q66. The switch receives a unicast data frame. If the destination MAC of the data frame can be ...
- Q67. What is the coverage area of an AP in WLAN?
- Q68. What is the length of the Ethernet_II frame containing the Ethernet header?...
- Q69. Which of the following information prompts will the VRP operating platform use for incompl...
- Q70. As shown in the figure below, suppose the MAC address table of SWA is as follows. Now host...
- Q71. Telnet is based on TCP protocol.
- Q72. Which of the following types of addresses is not included in IPv6 addresses?...
- Q73. By default, what is the STP Forward Delay time in seconds?...
- Q74. In which working state of the STP protocol can the port be changed to the Forwarding state...
- Q75. The network devices running the SNMP protocol are running locally-an agent process....
- Q76. Which of the following statements about the edge port in the RSTP protocol is correct?...
- Q77. Which statement about the Hybrid port is correct?...
- Q78. Which of the following fields does the ARP packet format include? (Multiple choice)...
- Q79. The configuration information of a interface of the router is shown in the figure, then wh...
- Q80. Which of the following functions does the LCP protocol in the PPP protocol support?...
- Q81. When the switch port sends a data frame carrying the same VLAN TAG and PVID, it must strip...
- Q82. The tree network topology is actually a hierarchical star structure, which is easy to expa...
- Q83. What is the value of TPID defined by IEEE802.1Q?...
- Q84. In the network shown in the figure below, the bridge ID of the switch has been marked. Ent...
- Q85. The output information of a switch is shown in the figure. Which of the following statemen...
- Q86. Which of the following statements about IPv6 multicast addresses are correct? (Multiple Ch...
- Q87. If the broadcast address of a network is 172.16.1.255, then what may its network address b...
- Q88. Which of the following IPv6 addresses is a multicast address?...
- Q89. Which of the following does not be included in AAA?...
- Q90. The role of the collaboration layer in the SDN architecture is to complete job deployment ...
- Q91. Which of the following descriptions are correct about the concept of IEV architecture? (Mu...
- Q92. Which of the following authentication methods does not require the user name and password?...
- Q93. On the VRP operating platform, what is the command to display the current interface config...
- Q94. If the largest number in an ACL rule is 12, by default, the user does not specify a number...
- Q95. The host's IPv4 address is 200.200.200.201/30. Which of the following hosts has an IPv4 ad...
- Q96. Refer to the route-in-a-stick configuration in the figure below, it can be judged that the...
- Q97. f a windows host is started for the first time, if the IP address is obtained by DHCP, the...
- Q98. Using a traditional landline to make calls is a way of network communication....
- Q99. In the RSTP standard, in order to improve the convergence speed, the port that the switch ...
- Q100. Which of the following port states is not included in the RSTP protocol?...
- Q101. Huawei ARG3 series routers have all SNMP versions (SNMPv1, SNMPv2c and SNMPv3) by default....
- Q102. Which of the following descriptions about wireless devices is correct?...
- Q103. The correct description of the information as shown in the figure is (). [R1]display inter...
- Q104. UDP cannot guarantee the reliability of data transmission, and does not provide functions ...
- Q105. What are the following characteristics of the default VLAN in the Layer 2 Ethernet switch?...
- Q106. The basic header length of IPv6 packets is a fixed value....
- Q107. Which extension headers are supported by IPv6 packets? (Multiple choice)...
- Q108. In the network shown in the figure below, host A is not configured with a gateway, and hos...
- Q109. Which field of the ipv6 packet header can be used for QoS?...
- Q110. The output information of a certain device is shown in the figure. Which of the following ...
- Q111. When Huawei switches allow STP, the priority of the switch is by default:...
- Q112. A DHCP server is deployed in the network, but the administrator found that some hosts did ...
- Q113. Which of the following description about the Layer 2 Ethernet switch is incorrect?...
- Q114. Which OSPF version below is suitable for IPv6?...
- Q115. Which of the following port states does the RSTP protocol include? (Multiple choice)...
- Q116. In the STP protocol, which of the following factors will affect the election of the root s...
- Q117. As shown in the figure below, which of the following statements are correct? (Exhibit)...
- Q118. The management of users by NAS devices is based on domains. Each user belongs to a domain,...
- Q119. The controller is the core component of SDN. The controller connects to the device through...
- Q120. The network management workstation manages network equipment through the SNMP protocol. Wh...
- Q121. Which statement about OSPF protocol DR is correct?...
