Join the discussion
Question 41/46
On the network shown in the figure, GE1/0/1 and GE1/0/2 of SW1 are access interfaces, and their PVIDs are VLAN 2 and VLAN 3 respectively. GE1/0/1 of SW2 is also an access interface, and its PVID is VLAN 4.
Which of the following configurations on SW1 and SW2 can ensure that data packets sent from PC1 and PC2 can reach PC3?

Which of the following configurations on SW1 and SW2 can ensure that data packets sent from PC1 and PC2 can reach PC3?

Correct Answer: B,C
PC1 and PC2 are in different VLANs on SW1, while PC3 is in VLAN 4 on SW2. To allow traffic from VLAN 2 and VLAN 3 users to reach PC3 through the inter-switch link, SW1 must be able to send frames from PC1 and PC2 toward SW2 in a form that SW2 can place into VLAN 4.
Option B is valid because a hybrid interface on SW1 can send frames from VLAN 2 and VLAN 3 untagged , and setting the PVID to VLAN 4 allows untagged inbound frames on the peer side to be associated appropriately when matched with the SW2 configuration. Option C is also valid because configuring SW2's GE1/0/3 as a trunk allowing VLAN 4 and setting its PVID to VLAN 4 means untagged frames arriving from SW1 are treated as belonging to VLAN 4 and can then be forwarded to PC3 through its access interface.
Option A is incomplete because only configuring SW2 does not solve the VLAN handling on SW1. Option D is incorrect because a trunk on SW1 would send VLAN 2 and VLAN 3 frames tagged, which would not match the VLAN 4-only expectation on SW2 in this scenario.
Option B is valid because a hybrid interface on SW1 can send frames from VLAN 2 and VLAN 3 untagged , and setting the PVID to VLAN 4 allows untagged inbound frames on the peer side to be associated appropriately when matched with the SW2 configuration. Option C is also valid because configuring SW2's GE1/0/3 as a trunk allowing VLAN 4 and setting its PVID to VLAN 4 means untagged frames arriving from SW1 are treated as belonging to VLAN 4 and can then be forwarded to PC3 through its access interface.
Option A is incomplete because only configuring SW2 does not solve the VLAN handling on SW1. Option D is incorrect because a trunk on SW1 would send VLAN 2 and VLAN 3 frames tagged, which would not match the VLAN 4-only expectation on SW2 in this scenario.
Add Comments
- Other Question (46q)
- Q1. If a network device has both a static route and a direct route to network 10.1.1.0/24, it ...
- Q2. On the network shown in the figure, all switches run STP. All links have a path cost of 20...
- Q3. In Layer 3 in-path WLAN networking, the WAC and Fit APs are connected at Layer 3. APs can ...
- Q4. When a host uses the stateless address autoconfiguration solution to obtain an IPv6 addres...
- Q5. OSPF has five types of packets. Which type is used to notify an OSPF neighbor of its requi...
- Q6. On the OSPF network shown in the figure, all IP addresses can communicate with each other....
- Q7. Which of the following is correct regarding the configuration of the trunk port and access...
- Q8. If a device running STP receives an RSTP configuration BPDU, it discards the BPDU....
- Q9. On an STP network, an administrator wants SW2 to be elected as the root bridge. Which of t...
- Q10. RSTP uses the proposal/agreement mechanism to shorten the time that an upstream port waits...
- Q11. On the switched network shown in the figure, STP is enabled on all devices. SW1 is the roo...
- Q12. R1 has four static routes, each of which has a reachable next hop. Given the following sta...
- Q13. In TCP/IP-based end-to-end communication, only the source and destination hosts process th...
- Q14. Which of the following are valid static route configurations?...
- Q15. R1 has the following configurations: [R1] nat address-group test 1 [R1-address-group-test]...
- Q16. R1 has the following configurations: [R1] radius-server template 1 [R1-radius-1] radius-se...
- Q17. The essence of communication is the transmission and exchange of information between two o...
- Q18. When a switch receives a unicast data frame, if the destination MAC address of the data fr...
- Q19. Both SNMP Trap and Inform Request are used by managed devices to send alarms to the NMS. I...
- Q20. If the neighbor relationship between R1 and R2 has reached the Full state in OSPF, which o...
- Q21. On the network shown in the figure, the administrator creates Eth-Trunk 1 in manual mode o...
- Q22. The figure shows the simplified topology of an enterprise campus network. On this network,...
- Q23. Which of the following phases are required for establishing a connection between an SSH se...
- Q24. Which of the following IPv6 addresses is a link-local address ?...
- Q25. Which of the following IPv6 addresses is a link-local address?...
- Q26. IEEE 802.11 is the standard for WLANs. Which of the following 802.11 protocols uses 1024-Q...
- Q27. Both SNMP Trap and Inform Request are used by managed devices to send alarms to the NMS. I...
- Q28. Secure Shell (SSH) is a protocol that uses encryption and authentication mechanisms to imp...
- Q29. The following command output is displayed on R1: [R1] display aaa configuration Domain Nam...
- Q30. After the root bridge is elected on an STP network, which of the following parameters may ...
- Q31. The traditional Fat AP networking usually applies to WLANs of small and micro stores. For ...
- Q32. On the network shown in the figure, R1 serves as the gateway for PC2 and PC3, and directly...
- Q33. In the STP topology shown in the figure, all links have the same path cost, and SW1 is the...
- Q34. The following command output is displayed on R1: [R1] display aaa configuration Domain Nam...
- Q35. In the figure, a web client sends an HTTP request to a web server, and the router in betwe...
- Q36. Which of the following hosts are reachable to the host at 192.168.1.200/27 at Layer 2? (Se...
- Q37. DAD enables a node to detect whether an IPv6 address is already in use by another node bef...
- Q38. Which of the following statements regarding static routing and dynamic routing is incorrec...
- Q39. On the network shown in the figure, GE1/0/1 and GE1/0/2 of SW1 are access interfaces, and ...
- Q40. Which of the following packets are exchanged between STAs and an AP to obtain the AP's SSI...
- Q41. On the network shown in the figure, GE1/0/1 and GE1/0/2 of SW1 are access interfaces, and ...
- Q42. IEEE 802.11 is the standard for WLANs. Which of the following 802.11 protocols uses 1024-Q...
- Q43. Network administrators need to manage and maintain devices on the campus network. Which of...
- Q44. The domain to which a user belongs is determined by the user name used by the user to log ...
- Q45. After the root bridge is elected on an STP network, which of the following parameters may ...
- Q46. In the figure, a web client sends an HTTP request to a web server, and the router in betwe...
