Join the discussion
Question 22/100
When configuring client-side 1+1 protection, if the working OTU and the protection OTU are on different network elements, the control channel board type can be OLP or SCS board
Correct Answer: A
Add Comments
- Other Question (100q)
- Q1. NE1 is connected to NE2. NE1 uses OptiX SDH equipment to use time slot of VC4:1:2. If the ...
- Q2. In the test item of IEEE 1588V2 time protection function, what is wrong?...
- Q3. When configuring the Ethernet service, the value of the J1 byte in the higher-order channe...
- Q4. Which of the following protections in microwave equipment does not require dual slots?...
- Q5. ODUk_PM_AIS alarm is one of the conditions for ODUK_SNCP switching...
- Q6. NG-SDH equipment allocates ECC channel numbers according to certain principles. For exampl...
- Q7. What are the TDM circuit simulation encapsulation protocols? (multiple choice)...
- Q8. Regarding system security planning and reliability planning, which of the following is cor...
- Q9. Regarding the interconnection of different circuit boards of OTN equipment, which of the f...
- Q10. Preparation conditions for single-site commissioning of transmission equipment include (mu...
- Q11. Four network elements A, B, C, and D form an SNCP ring, and there are a large number of PD...
- Q12. What's wrong with the description of the 1+1 protection on the client side?...
- Q13. In the 40-wavelength system of the wavelength division equipment, due to the aging of the ...
- Q14. Corresponding to the ISO seven-layer model, Ethernet corresponds to the physical and netwo...
- Q15. To share the business of VCTRUNK, to achieve business isolation, what isolation methods ca...
- Q16. Which of the following descriptions about PTN setting TPS protection are correct? (multipl...
- Q17. For 10G and coherent 100G mixed transmission systems, the following description is correct...
- Q18. In the U2000 dual-system hot backup system, the active site fails and the standby site fai...
- Q19. XPIC can be used in conjunction with ATPC, but it is generally not recommended. If it need...
- Q20. In the Linux system, configure an IP address of 129.9.1.100 for the network card Eth0, and...
- Q21. Hybrid MSTP devices support cross-domain clock intercommunication, and support the interco...
- Q22. When configuring client-side 1+1 protection, if the working OTU and the protection OTU are...
- Q23. The 1588V2 clock enters the non-tracking working mode, and the alarm CLOCK_NO_TRACE_MODE i...
- Q24. What problems in the network cannot be solved by QoS?...
- Q25. MSTP equipment TDM plane can support 1588V2
- Q26. The single-fiber bidirectional optical interface of PTN equipment distinguishes upstream a...
- Q27. Discrete services are cross-connections with no path formed on the network management. Sin...
- Q28. When configuring the Ethernet EPLAN service, VB will be created on all the sites above and...
- Q29. Regarding the 10G/100G mixed transmission wavelength isolation band, is the following stat...
- Q30. PTN equipment realizes the unified bearing of multiple services through PWE3. For users, t...
- Q31. Which of the following statements about OTN overhead is correct? () (multiple choice)...
- Q32. The following about DCN network planning, the error is...
- Q33. When planning AM, you need to consider the priority planning of E1. Which of the following...
- Q34. Which of the following descriptions are correct for error alarms (multiple choice)...
- Q35. Which of the following statements about OTN reuse and overhead is wrong? ()...
- Q36. The function of PW OAM is basically the same as that of Tunnel. The PW OAM mechanism can e...
- Q37. A certain network is configured with SOM. When performing path performance analysis, the O...
- Q38. Regarding the optical power commissioning of the RAU2 board, which of the following option...
- Q39. Swap antennas is to align the main lobes of the antennas at both ends to each other, and t...
- Q40. What's not a trivial task for ASON's business recovery is...
- Q41. Which of the following statements about the configuration, testing and maintenance of IPA ...
- Q42. The maximum number of VBs supported by the EGS4 series of OSN equipment is two, and the ma...
- Q43. In general, which PHB is the signaling flag?
- Q44. Generally, which of the following is not included in the performance evaluation of a WDM n...
- Q45. In the process of U2000 network management searching for paths, the path search management...
- Q46. In the Linux system, the directory tree structure and the file system are two different co...
- Q47. The following authorizations need to be obtained for the live network change operation (mu...
- Q48. The upgrade from GACSA to UXCSB for OSN 3500 equipment is as follows: 1. Replace the spare...
- Q49. Which of the following IP addresses is a class C IP address...
- Q50. Regarding the M40 and D40 channel isolation indicators of OSN 8800/6800 devices, which of ...
- Q51. Regarding the OSNR test of the OTN system, which of the following statements is correct? (...
- Q52. If OSS is connected to the CORBA interface, a session connection is established between U2...
- Q53. It is found that the U2000 dual machine of the customer network is in the dual master stat...
- Q54. In an ASON network, if the control channel between two network elements is blocked, which ...
- Q55. Regarding the reporting of the OTUk_BDI alarm, the following statement is wrong....
- Q56. A network is configured with 1+1 protection on the board. On a certain day, the working ch...
- Q57. Which of the following descriptions of ODUk SNCP protection types are wrong?...
- Q58. According to the requirements, before OTN 6800/8800 equipment is upgraded, it is necessary...
- Q59. What should I pay attention to when swapping antennas? (multiple choices)...
- Q60. When which of the following pointers is adjusted, the information payload area carries the...
- Q61. Network elements A, B, and C are OSN 3500 forming a chain network. The two stations A and ...
- Q62. The interface board N1SF64 of OSN 7500 and the A1SF64 of OptiX 10G (Metro 5000) support di...
- Q63. After which of the following steps, the rollback operation can no longer be performed...
- Q64. Regarding the description of OSS, what is wrong is...
- Q65. If the OSN6800 device wants to achieve 1588V2 time synchronization, it must be configured ...
- Q66. After the AM function of the microwave equipment is enabled, the signal level of the high ...
- Q67. Regarding U2000 dual-machine deployment, the following statement is wrong ()...
- Q68. When the SDH device configures the Ethernet layer 2 switching service, the switch forwards...
- Q69. The main survey points of engineering survey are (multiple choices)...
- Q70. TN55TQX+TN53NQ2 network element) -----TN53NQ2+TN55TQX (B network element) networking, the ...
- Q71. When 15 VC-12 services are created on the STM-1 frame in sequence from 1 to 15, and then V...
- Q72. Regarding the differences between Linux and Solaris operating systems, the following state...
- Q73. During the degrading process of the smart business, the intermediate node is reset, and th...
- Q74. There is a lower limit for the length of the Ethernet frame. What is the main reason for t...
- Q75. What is correct about traffic policing and traffic shaping?...
- Q76. Among the following methods, which is the most effective way to avoid discrete business?...
- Q77. What is the wavelength of the OSC channel of Huawei OTN equipment? () (multiple choice)...
- Q78. Which of the following are the functions of MPLS-TP OAM? (multiple choice)...
- Q79. User A and user B belong to the Team group. User A has a file File1. After running the com...
- Q80. Before configuring SOM, the physical fiber connection from OMCA to the optical amplifier b...
- Q81. The EDFA in the OAU board has a gain lock function. When the optical signal of one or seve...
- Q82. What are the limiting factors of CES ACR synchronization? (multiple choice)...
- Q83. NE1, NE2, NE3, NE4, and NE5 form an MSP ring, and there is an STM-1 link between NE1 and N...
- Q84. In the point-to-point WDM networking scenario, the signal-to-noise ratio of a certain sing...
- Q85. Which of the following abnormal conditions will trigger the TPS protection switching of th...
- Q86. The scope of 1+1 protection in the OTU board is the optical fiber on the OCH path, that is...
- Q87. An intelligent clock subnet can realize the automatic tracking and automatic switching of ...
- Q88. The existing network needs to be transformed into 1+1 line protection of OMS, the followin...
- Q89. A certain system is configured with SOM, only the optical power information is in the quer...
- Q90. SYNLOCK V3 devices can achieve different clock accuracy levels through different board con...
- Q91. Four network elements A, B, C, and D form a two-fiber bidirectional multiplex section shar...
- Q92. When congestion occurs, queuing strategies can be varied. If you need to take service for ...
- Q93. As shown below: (Exhibit) The service of station A is broadcast to station B and station C...
- Q94. N3EGS2 supports which of the following protections?...
- Q95. The ODU product label is shown in the picture. Which of the following statements is correc...
- Q96. In microwave products, which of the following protection methods can enable reverse switch...
- Q97. Regarding the description of SNMP, the following description is wrong...
- Q98. The test frame is a data message used to test the network connection status of the Etherne...
- Q99. Use end-to-end path configuration circuit on the network management, then there will be no...
- Q100. The following description of OLP optical line protection is wrong:...
