Join the discussion
Question 1/72
PDM uses a polarization beam splitter to divide the laser into two vertical directions: x and y.
Correct Answer: B
Add Comments
- Other Question (72q)
- Q1. PDM uses a polarization beam splitter to divide the laser into two vertical directions: x ...
- Q2. In a 2.5GMSP ring consisting of four MSTP sites, which of the following statements about a...
- Q3. Which of the following statements regarding multiplexing partial remote error indication (...
- Q4. Which of the following is the frame indicated by the VC-4 J1 byte by the AU pointer of the...
- Q5. The refractive index n1 of the fiber core must be the Q of the cladding refractive Mo n2, ...
- Q6. The device IP address of the gateway element and the non-gateway element must be set in th...
- Q7. Which of the following is the feature of TCM overhead in ODUk signals?...
- Q8. Which of the following is not the advantage of WDM?...
- Q9. The receiver performs a BIP-8 check on unscrambled STM-16 frames. If the BIP8 check result...
- Q10. SDH signals must be scrambled before they can be transmitted over optical fibers. Which of...
- Q11. Which of the following is not a condition that triggers multiplexed segment protection (MS...
- Q12. Which of the following layers define the protocols that control the network layer? The pro...
- Q13. The number of ODU2e signals multiplexed into the ODU3 signal is the same as the number of ...
- Q14. Which of the following statements about the OTM-n .m and OTMnr .m for OTN are incorrect?...
- Q15. Which of the following is the multiplexing method of SDH?...
- Q16. Only one TCM can be used at one site
- Q17. QinQ technology can be used when multiple users need to share the same VCTRUNK and use the...
- Q18. OSN1500/2500/3500/7500 supports DC and AC power inputs....
- Q19. In WDM systems, it is ideal to use a dielectric thin problem filter (TFF) when using less ...
- Q20. When the ACT indicator of the SDH board is off, it means that the board has a hardware fai...
- Q21. Are the following statements regarding the definition of SDH correct?...
- Q22. For (on-premises) HA solutions where active and standby servers are deployed in the same l...
- Q23. Which of the following is the maximum number of OSN3500 sub-racks that can be installed in...
- Q24. When the J1 byte does not match, an alarm () is reported and the service may be interrupte...
- Q25. The number of bit error blocks on each VC4 channel is detected by B3 on the receiving side...
- Q26. When performing fiber cut-off test on an ordinary MSP ring, which of the following alarms ...
- Q27. Which of the following is photolayer tracking? (Multiple Choices)...
- Q28. The dual fiber ring topology consisting of three network elements is arranged in countercl...
- Q29. STM-64 has an () AU pointer.
- Q30. When setting up LCAS mode, follow these principles: 1. If both ends of the device are Huaw...
- Q31. Which of the following logic function blocks are involved in processing clock signals? (Mu...
- Q32. Both PDH and SDH have globally harmonized standards....
- Q33. Which of the following alerts does not trigger an AU-AIS alert?...
- Q34. Which of the following statements about the MSP ring is correct? (Multiple choice)....
- Q35. The interval between two adjacent pointer alignment events is at least () frames....
- Q36. The last 256 columns in the OTN frame structure are the FEC regions for forward error corr...
- Q37. Which of the following alarm/event storage modes does U2000 support? (Multiple choice)....
- Q38. On OSN Series transmission devices, ethernet ports cannot access tagged and untagged frame...
- Q39. The SP3D board supports 63 E1 services
- Q40. RSOH, MSOH, HPOH and LPOH implement the monitoring function in descending order of the mon...
- Q41. Which of the following statements about basic LCAS functionality are correct? (Multiple ch...
- Q42. The optical amplifier unit compensates for line losses and extends the transmission distan...
- Q43. Which of the following device domains can be managed by U2000? (Multiple choice)....
- Q44. Forced switching, fiber switching, manual switching and motion switching are decreased in ...
- Q45. Which of the following bytes can be used for ordenwire calls between two REG devices?...
- Q46. LCK insertion takes precedence over AIS insertion. That is, if the user configures LCK ins...
- Q47. On the NMS system, the network element performance monitoring time is set to () minutes an...
- Q48. In the OSN550, the CXL slot contains a function board that integrates a system control and...
- Q49. The OTN signal has a fixed pad period, the same frame period as the SDH signal....
- Q50. The index is used to folio and delineate the starting position of VC-n in the correspondin...
- Q51. For 100G (112Gbit/s) signals, the actual data baud rate is only 28G amplitude....
- Q52. When there is a Critical Error In Seconds (SES) in the PM portion of the ODUk layer, which...
- Q53. NE A and NE B are adjacent NE If B3 and low-order errors occur in the A->B direction, a...
- Q54. Which factors determine the optical signal-to-noise ratio (OSNR) of the receiving end to a...
- Q55. For OSN3500, there is a slot mapping relationship between the processing board and the int...
- Q56. Which of the following statements about the clock source are incorrect?...
- Q57. When using a script to back up and restore network configuration data for the U2000, you c...
- Q58. Automatic Laser Shutdown (ALS): When no optical signal is received, the ALS function autom...
- Q59. output networks require higher costs than belt networks, but provide a more reliable manag...
- Q60. During service configuration, there are two time slot modes. Huawei uses interleaved time ...
- Q61. By default, B2-EXC alerts are reported when the number of B2 bit errors exceeds the () thr...
- Q62. In the system control unit, which of the following databases does not lose data after a po...
- Q63. When the working PQ1 board is oversized, the device will perform and the TFS protection wi...
- Q64. Which of the following maintenance signals is transmitted from the downstream site to the ...
- Q65. The value of the MFAS byte increases with the sequence number of the OTUk/ODUK base frame ...
- Q66. WDM transmits optical signals multiplexed at multiple rates (wavelengths) through a single...
- Q67. OTM nr.m consists of up to n " multiplexed channels and does not support non-channel-relat...
- Q68. For osn3500, which of the following boards provides centralized backup capability for the ...
- Q69. Which of the following is the configuration mode for the new NE?( Multiple choices)....
- Q70. Which of the following statements regarding the protection of the cross-connecting plate 1...
- Q71. Which of the following bytes in the regenerator part overhead are associated with R-OOF an...
- Q72. Which of the following can be used as the central wavelength of the pump source in EDFA? (...
