Join the discussion
Question 1/23
You are configuring an IS-IS IGP network and do not see the IS-IS adjacencies established. In this scenario, what are two reasons for this problem? (Choose two.)
Correct Answer: A,D
Explanation
Option A suggests that the MTU is not at least 1492 bytes. This is correct because IS-IS requires a minimum MTU of 1492 bytes to establish adjacencies1. If the MTU is less than this, IS-IS adjacencies will not be established1.
Option D suggests that the lo0 interface is not included as an IS-IS interface. This is also correct because the loopback interface (lo0) is typically used as the router ID in IS-IS1. If the loopback interface is not included in IS-IS, it could prevent IS-IS adjacencies from being established1.
Therefore, options A and D are correct.
Option A suggests that the MTU is not at least 1492 bytes. This is correct because IS-IS requires a minimum MTU of 1492 bytes to establish adjacencies1. If the MTU is less than this, IS-IS adjacencies will not be established1.
Option D suggests that the lo0 interface is not included as an IS-IS interface. This is also correct because the loopback interface (lo0) is typically used as the router ID in IS-IS1. If the loopback interface is not included in IS-IS, it could prevent IS-IS adjacencies from being established1.
Therefore, options A and D are correct.
Add Comments
- Other Question (23q)
- Q1. You are configuring an IS-IS IGP network and do not see the IS-IS adjacencies established....
- Q2. Exhibit. (Exhibit) What is the management IP address of the device shown in the exhibit?...
- Q3. Exhibit. (Exhibit) You want to verify prefix information being sent from 10.36.1.4. Which ...
- Q4. Exhibit (Exhibit) You have configured a GRE tunnel. To reduce the risk of dropping traffic...
- Q5. Exhibit (Exhibit) You are a network operator troubleshooting BGP connectivity. Which two s...
- Q6. You are a network operator who wants to add a second ISP connection and remove the default...
- Q7. You want to ensure traffic is routed through a GRE tunnel. In this scenario, which two sta...
- Q8. In RSTP, which three port roles are associated with the discarding state? (Choose three.)...
- Q9. You are attempting to configure the initial two aggregated Ethernet interfaces on a router...
- Q10. You want to use filter-based forwarding (FBF) on your Internet peering router to load-bala...
- Q11. What are two reasons for creating multiple areas in OSPF? (Choose two.)...
- Q12. Which two statements are correct about generated routes? (Choose two.)...
- Q13. You need to configure a LAG between your switches. In this scenario, which two statements ...
- Q14. You implemented the MAC address limit feature with the shutdown action on all interfaces o...
- Q15. What is a purpose of using a spanning tree protocol?...
- Q16. Exhibit (Exhibit) You are troubleshooting an issue where traffic to 192.168.10.0/24 is bei...
- Q17. Which two statements about redundant trunk groups on EX Series switches are correct? (Choo...
- Q18. Which two statements about BGP facilitate the prevention of routing loops between two auto...
- Q19. You are asked to connect an IP phone and a user computer using the same interface on an EX...
- Q20. Exhibit (Exhibit) You are receiving the BGP route shown in the exhibit from four different...
- Q21. Which three protocols support BFD? (Choose three.)...
- Q22. Which statement is correct about IP-IP tunnels?...
- Q23. You are receiving multiple BGP routes from an upstream neighbor and only want to advertise...
