1. Home
  2. NACE
  3. Coating Inspector Level 1
  4. NACE.NACE-CIP1-001.v2023-04-01.q34
  5. Question 2
Verified By Experts
40%off

NACE-CIP1-001 Premium Bundle

Latest NACE-CIP1-001 Exam Premium Dumps provide by TrainingDump.com to help you Passing NACE-CIP1-001 Exam! TrainingDump.com offers the updated NACE-CIP1-001 exam dumps, the TrainingDump.com NACE-CIP1-001 exam questions has been updated to correct Answer. Get the latest TrainingDump.com NACE-CIP1-001 pdf dumps with Exam Engine here:


(100 Q&As Dumps, 40%OFF Special Discount: DumpsFiles)

Join the discussion

Question 2/34

When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

Add Comments

Your email address will not be published. Required fields are marked *

insert code
Type the characters from the picture.
Other Question (34q)
Q1. What is the minimum recommended distance away from an edge that an inspector should take a...
Q2. When holiday testing is required the Inspector is always required to enforce NACE SP 0188:...
Q3. A magnetic pull-off type gauge is a good choice when:...
Q4. Osmotic blistering is most likely to occur as a result of...
Q5. Owners hire NACE Inspectors' with the expectation that:...
Q6. Removal of surface contaminants is done by:
Q7. The primary difference between Non-Convertible vs. Convertible coatings is:...
Q8. A NACE Coating Inspector is permitted to transport coating material when:...
Q9. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
Q10. Passivation can best be described as:
Q11. Which one of the following documents is the best source for coating technical data:...
Q12. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) ar...
Q13. The main responsibilities of the inspector are to...
Q14. Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Of...
Q15. Checking is
Q16. ISO SA 2 is defined as:
Q17. Which is a component that supplies most of the features and functions of the material?...
Q18. Solvents are added to coating formulations to
Q19. Inspector's daily reports are used: Select All That Apply...
Q20. If inspectors identify issues of non-conformance during an inspection, they should...
Q21. ASTM Standards are applicable:
Q22. Check abrasive blast pressure close to the
Q23. SSPC SP 1 identifies the use of:
Q24. The Inspector's Log Book is generally:
Q25. On a blast-cleaned surface, Ian ultraviolet light is generally used to detect...
Q26. The Inspector should record the serial numbers of inspection instruments:...
Q27. You ate the NACE Inspector on a job where NACE No. 2/SSPC - SP 10 has been specified. You ...
Q28. Removal of welds splatter is required:
Q29. Silicone coatings are typically:
Q30. Inspection documentation is important because:...
Q31. You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified. Assum...
Q32. According to SSPC PA 2 a Spot Measurement is:
Q33. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector s...
Q34. Whenever dissimilar metals must join, the most common practice is to...