Join the discussion
Question 17/34
Which is a component that supplies most of the features and functions of the material?
Correct Answer: B
Add Comments
- Other Question (34q)
- Q1. What is the minimum recommended distance away from an edge that an inspector should take a...
- Q2. When holiday testing is required the Inspector is always required to enforce NACE SP 0188:...
- Q3. A magnetic pull-off type gauge is a good choice when:...
- Q4. Osmotic blistering is most likely to occur as a result of...
- Q5. Owners hire NACE Inspectors' with the expectation that:...
- Q6. Removal of surface contaminants is done by:
- Q7. The primary difference between Non-Convertible vs. Convertible coatings is:...
- Q8. A NACE Coating Inspector is permitted to transport coating material when:...
- Q9. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
- Q10. Passivation can best be described as:
- Q11. Which one of the following documents is the best source for coating technical data:...
- Q12. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) ar...
- Q13. The main responsibilities of the inspector are to...
- Q14. Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Of...
- Q15. Checking is
- Q16. ISO SA 2 is defined as:
- Q17. Which is a component that supplies most of the features and functions of the material?...
- Q18. Solvents are added to coating formulations to
- Q19. Inspector's daily reports are used: Select All That Apply...
- Q20. If inspectors identify issues of non-conformance during an inspection, they should...
- Q21. ASTM Standards are applicable:
- Q22. Check abrasive blast pressure close to the
- Q23. SSPC SP 1 identifies the use of:
- Q24. The Inspector's Log Book is generally:
- Q25. On a blast-cleaned surface, Ian ultraviolet light is generally used to detect...
- Q26. The Inspector should record the serial numbers of inspection instruments:...
- Q27. You ate the NACE Inspector on a job where NACE No. 2/SSPC - SP 10 has been specified. You ...
- Q28. Removal of welds splatter is required:
- Q29. Silicone coatings are typically:
- Q30. Inspection documentation is important because:...
- Q31. You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified. Assum...
- Q32. According to SSPC PA 2 a Spot Measurement is:
- Q33. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector s...
- Q34. Whenever dissimilar metals must join, the most common practice is to...
