- Other Question (35q)
- Q1. ISO ST 3 is described as:
- Q2. A NACE Coating Inspector is permitted to transport coating material when:...
- Q3. Inspection documentation is important because:...
- Q4. When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in ...
- Q5. You ate the NACE Inspector on a job where NACE No. 2/SSPC - SP 10 has been specified. You ...
- Q6. Digital hygrometers
- Q7. Good records can provide maintenance departments with detailed information about ALL of th...
- Q8. Dew point is the temperature at which
- Q9. The NACE Inspector should perform tests for soluble salts:...
- Q10. You are the NACE Inspector on a job where the Owner's specification requites you to perfor...
- Q11. If the project specification DOES NOT state the specific DFT measurement standards, the in...
- Q12. What is the minimum recommended distance away from an edge that an inspector should take a...
- Q13. Most industrial coatings are:
- Q14. Passivation can best be described as:
- Q15. Stripe coats are generally applied to:
- Q16. Upon arrival of coating materials, the inspector should...
- Q17. As a NACE Coating Inspector your responsibility with respect to safety is to:...
- Q18. Checking is
- Q19. SSPC SP 1 identifies the use of:
- Q20. According to SSPC PA 2 a Spot Measurement is:
- Q21. If a Thermoset coating is heated it will:
- Q22. A single application coating film has a measured dry film thickness (DFT) between 4 and 5 ...
- Q23. The Inspector should record the serial numbers of inspection instruments:...
- Q24. What is used to determine compressed air cleanliness?...
- Q25. Corrosion generally occurs at which of the following sites:...
- Q26. If inspectors identify issues of non-conformance during an inspection, they should...
- Q27. ASTM Standards are applicable:
- Q28. Prior to using Inspection Tools the inspector must:...
- Q29. In a non-convertible coating the role of the primary solvent is to:...
- Q30. Galvanic corrosion occurs on which of the following substrates:...
- Q31. NACE SP 0178 is a standard for:
- Q32. You are an inspector on a project where SSPC SP 3 is specified. What sort of tools should ...
- Q33. Excess moisture during holiday testing can cause erroneous indications by creating a path ...
- Q34. The least effective method of surface cleaning is most likely...
- Q35. Excessive working of the surface with a power grinder can be detrimental because excessive...
