1. Home
  2. NACE
  3. Coating Inspector Level 1
  4. NACE.NACE-CIP1-001.v2023-06-07.q35
  5. Question 22
Verified By Experts
40%off

NACE-CIP1-001 Premium Bundle

Latest NACE-CIP1-001 Exam Premium Dumps provide by TrainingDump.com to help you Passing NACE-CIP1-001 Exam! TrainingDump.com offers the updated NACE-CIP1-001 exam dumps, the TrainingDump.com NACE-CIP1-001 exam questions has been updated to correct Answer. Get the latest TrainingDump.com NACE-CIP1-001 pdf dumps with Exam Engine here:


(100 Q&As Dumps, 40%OFF Special Discount: DumpsFiles)

Join the discussion

Question 22/35

If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

Add Comments

Your email address will not be published. Required fields are marked *

insert code
Type the characters from the picture.
Other Question (35q)
Q1. The form of corrosion that has the largest potential for unexpected catastrophic failure i...
Q2. A single application coating film has a measured dry film thickness (DFT) between 4 and 5 ...
Q3. Which one of these elements is not necessary for corrosion to occur:...
Q4. To be of value the Inspector's documentation must be:...
Q5. You are the NACE Inspector on a job where the Owner's specification requites you to perfor...
Q6. Prior to using Inspection Tools the inspector must:...
Q7. Stripe coats are best applied by:
Q8. Upon arrival of coating materials, the inspector should...
Q9. Inspection documentation is important because:...
Q10. In the event of a conflict between the project specification and the coating manufactures'...
Q11. Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Of...
Q12. You are asked to be the only coating inspector on a small bridge recoating job where exist...
Q13. Removal of welds splatter is required:
Q14. Solvents are added to coating formulations to
Q15. Surface profile describes:
Q16. Daily reports are important because: Select All That Apply...
Q17. Conventional spray is a good choice when:
Q18. ISO SA 2 is defined as:
Q19. When using the ISO comparator in accordance with ISO 8503, if the surface profile does not...
Q20. Owners hire NACE Inspectors' with the expectation that:...
Q21. ISO SA 3 is directly equivalent to:
Q22. If the project specification DOES NOT state the specific DFT measurement standards, the in...
Q23. Due to a previous premature coating failure the owner has required the original coating ap...
Q24. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
Q25. The primary difference between Non-Convertible vs. Convertible coatings is:...
Q26. Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gau...
Q27. Which one of the following documents is the best source for coating technical data:...
Q28. You are an inspector on a project where SSPC SP 3 is specified. What sort of tools should ...
Q29. When using a sling physchrometer a very large difference between the wet and dry bulb read...
Q30. An inspectors personal log book should contain:...
Q31. Most industrial coatings are:
Q32. NACE Level 1 Inspectors have been trained to perform:...
Q33. Inspector's daily reports are used: Select All That Apply...
Q34. When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in ...
Q35. You are the NACE Coating Inspector on an exterior job where the contractor is not using an...