Join the discussion
Question 10/35
In the event of a conflict between the project specification and the coating manufactures' product data sheet, the Inspector's first course of action should be too:
Correct Answer: D
Add Comments
- Other Question (35q)
- Q1. The form of corrosion that has the largest potential for unexpected catastrophic failure i...
- Q2. A single application coating film has a measured dry film thickness (DFT) between 4 and 5 ...
- Q3. Which one of these elements is not necessary for corrosion to occur:...
- Q4. To be of value the Inspector's documentation must be:...
- Q5. You are the NACE Inspector on a job where the Owner's specification requites you to perfor...
- Q6. Prior to using Inspection Tools the inspector must:...
- Q7. Stripe coats are best applied by:
- Q8. Upon arrival of coating materials, the inspector should...
- Q9. Inspection documentation is important because:...
- Q10. In the event of a conflict between the project specification and the coating manufactures'...
- Q11. Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Of...
- Q12. You are asked to be the only coating inspector on a small bridge recoating job where exist...
- Q13. Removal of welds splatter is required:
- Q14. Solvents are added to coating formulations to
- Q15. Surface profile describes:
- Q16. Daily reports are important because: Select All That Apply...
- Q17. Conventional spray is a good choice when:
- Q18. ISO SA 2 is defined as:
- Q19. When using the ISO comparator in accordance with ISO 8503, if the surface profile does not...
- Q20. Owners hire NACE Inspectors' with the expectation that:...
- Q21. ISO SA 3 is directly equivalent to:
- Q22. If the project specification DOES NOT state the specific DFT measurement standards, the in...
- Q23. Due to a previous premature coating failure the owner has required the original coating ap...
- Q24. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
- Q25. The primary difference between Non-Convertible vs. Convertible coatings is:...
- Q26. Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gau...
- Q27. Which one of the following documents is the best source for coating technical data:...
- Q28. You are an inspector on a project where SSPC SP 3 is specified. What sort of tools should ...
- Q29. When using a sling physchrometer a very large difference between the wet and dry bulb read...
- Q30. An inspectors personal log book should contain:...
- Q31. Most industrial coatings are:
- Q32. NACE Level 1 Inspectors have been trained to perform:...
- Q33. Inspector's daily reports are used: Select All That Apply...
- Q34. When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in ...
- Q35. You are the NACE Coating Inspector on an exterior job where the contractor is not using an...
