1. Home
  2. NACE
  3. Coating Inspector Level 1
  4. NACE.NACE-CIP1-001.v2024-09-14.q33
  5. Question 17
Verified By Experts
40%off

NACE-CIP1-001 Premium Bundle

Latest NACE-CIP1-001 Exam Premium Dumps provide by TrainingDump.com to help you Passing NACE-CIP1-001 Exam! TrainingDump.com offers the updated NACE-CIP1-001 exam dumps, the TrainingDump.com NACE-CIP1-001 exam questions has been updated to correct Answer. Get the latest TrainingDump.com NACE-CIP1-001 pdf dumps with Exam Engine here:


(100 Q&As Dumps, 40%OFF Special Discount: DumpsFiles)

Join the discussion

Question 17/33

How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

Add Comments

Your email address will not be published. Required fields are marked *

insert code
Type the characters from the picture.
Other Question (33q)
Q1. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) ar...
Q2. Corrosion generally occurs at which of the following sites:...
Q3. The least effective method of surface cleaning is most likely...
Q4. According to SSPC PA 2 a Spot Measurement is:
Q5. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
Q6. If a contractor is using a poorly maintained compressor to supply air for abrasive blast c...
Q7. Which one of these elements is not necessary for corrosion to occur:...
Q8. The form of corrosion that has the largest potential for unexpected catastrophic failure i...
Q9. If the specifier does not identify a restriction level in accordance with SSPC PA 2, the d...
Q10. To be of value the Inspector's documentation must be:...
Q11. Solvents are added to coating formulations to
Q12. Which is a component that supplies most of the features and functions of the material?...
Q13. It is good practice for the NACE Inspector to have instrument calibration certificates ava...
Q14. SSPC SP 1 identifies the use of:
Q15. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector s...
Q16. An Inspector should change position when:
Q17. How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?...
Q18. Osmotic blistering is most likely to occur as a result of...
Q19. When using the ISO comparator in accordance with ISO 8503, if the surface profile does not...
Q20. Conventional spray is a good choice when:
Q21. Check abrasive blast pressure with a
Q22. Galvanic corrosion occurs on which of the following substrates:...
Q23. ISO SA 2.5 is defined as:
Q24. You are the NACE Coating Inspector on an exterior job where the contractor is not using an...
Q25. Removal of welds splatter is required:
Q26. Relative humidity is
Q27. As a NACE Coating Inspector your responsibility with respect to safety is to:...
Q28. Most industrial coatings are:
Q29. The primary difference between Non-Convertible vs. Convertible coatings is:...
Q30. Good records can provide maintenance departments with detailed information about ALL of th...
Q31. The most important factor resulting in improved job site safety is:...
Q32. An inspectors personal log book should contain:...
Q33. Which one of the following documents is the best source for coating technical data:...