Join the discussion
Question 1/33
What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?
Correct Answer: D
Add Comments
- Other Question (33q)
- Q1. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) ar...
- Q2. Corrosion generally occurs at which of the following sites:...
- Q3. The least effective method of surface cleaning is most likely...
- Q4. According to SSPC PA 2 a Spot Measurement is:
- Q5. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
- Q6. If a contractor is using a poorly maintained compressor to supply air for abrasive blast c...
- Q7. Which one of these elements is not necessary for corrosion to occur:...
- Q8. The form of corrosion that has the largest potential for unexpected catastrophic failure i...
- Q9. If the specifier does not identify a restriction level in accordance with SSPC PA 2, the d...
- Q10. To be of value the Inspector's documentation must be:...
- Q11. Solvents are added to coating formulations to
- Q12. Which is a component that supplies most of the features and functions of the material?...
- Q13. It is good practice for the NACE Inspector to have instrument calibration certificates ava...
- Q14. SSPC SP 1 identifies the use of:
- Q15. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector s...
- Q16. An Inspector should change position when:
- Q17. How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?...
- Q18. Osmotic blistering is most likely to occur as a result of...
- Q19. When using the ISO comparator in accordance with ISO 8503, if the surface profile does not...
- Q20. Conventional spray is a good choice when:
- Q21. Check abrasive blast pressure with a
- Q22. Galvanic corrosion occurs on which of the following substrates:...
- Q23. ISO SA 2.5 is defined as:
- Q24. You are the NACE Coating Inspector on an exterior job where the contractor is not using an...
- Q25. Removal of welds splatter is required:
- Q26. Relative humidity is
- Q27. As a NACE Coating Inspector your responsibility with respect to safety is to:...
- Q28. Most industrial coatings are:
- Q29. The primary difference between Non-Convertible vs. Convertible coatings is:...
- Q30. Good records can provide maintenance departments with detailed information about ALL of th...
- Q31. The most important factor resulting in improved job site safety is:...
- Q32. An inspectors personal log book should contain:...
- Q33. Which one of the following documents is the best source for coating technical data:...
