Join the discussion
Question 5/33
You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:
Your FIRST preferred course of action is to:
Correct Answer: D
Add Comments
- Other Question (33q)
- Q1. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) ar...
- Q2. Corrosion generally occurs at which of the following sites:...
- Q3. The least effective method of surface cleaning is most likely...
- Q4. According to SSPC PA 2 a Spot Measurement is:
- Q5. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining i...
- Q6. If a contractor is using a poorly maintained compressor to supply air for abrasive blast c...
- Q7. Which one of these elements is not necessary for corrosion to occur:...
- Q8. The form of corrosion that has the largest potential for unexpected catastrophic failure i...
- Q9. If the specifier does not identify a restriction level in accordance with SSPC PA 2, the d...
- Q10. To be of value the Inspector's documentation must be:...
- Q11. Solvents are added to coating formulations to
- Q12. Which is a component that supplies most of the features and functions of the material?...
- Q13. It is good practice for the NACE Inspector to have instrument calibration certificates ava...
- Q14. SSPC SP 1 identifies the use of:
- Q15. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector s...
- Q16. An Inspector should change position when:
- Q17. How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?...
- Q18. Osmotic blistering is most likely to occur as a result of...
- Q19. When using the ISO comparator in accordance with ISO 8503, if the surface profile does not...
- Q20. Conventional spray is a good choice when:
- Q21. Check abrasive blast pressure with a
- Q22. Galvanic corrosion occurs on which of the following substrates:...
- Q23. ISO SA 2.5 is defined as:
- Q24. You are the NACE Coating Inspector on an exterior job where the contractor is not using an...
- Q25. Removal of welds splatter is required:
- Q26. Relative humidity is
- Q27. As a NACE Coating Inspector your responsibility with respect to safety is to:...
- Q28. Most industrial coatings are:
- Q29. The primary difference between Non-Convertible vs. Convertible coatings is:...
- Q30. Good records can provide maintenance departments with detailed information about ALL of th...
- Q31. The most important factor resulting in improved job site safety is:...
- Q32. An inspectors personal log book should contain:...
- Q33. Which one of the following documents is the best source for coating technical data:...
